[PATCH 1/3] pinctrl: at91: correct a few typos

[Alexandre Belloni]

Signed-off-by: Alexandre Belloni <alexandre.belloni@xxxxxxxxxxxxxxxxxx>
---
 drivers/pinctrl/pinctrl-at91.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/pinctrl/pinctrl-at91.c b/drivers/pinctrl/pinctrl-at91.c
index a7549c4c83b4..6446dc804aa7 100644
--- a/drivers/pinctrl/pinctrl-at91.c
+++ b/drivers/pinctrl/pinctrl-at91.c
@@ -118,7 +118,7 @@ struct at91_pin_group {
 };
 
 /**
- * struct at91_pinctrl_mux_ops - describes an At91 mux ops group
+ * struct at91_pinctrl_mux_ops - describes an AT91 mux ops group
  * on new IP with support for periph C and D the way to mux in
  * periph A and B has changed
  * So provide the right call back
@@ -1396,7 +1396,7 @@ static void gpio_irq_handler(unsigned irq, struct irq_desc *desc)
 	chained_irq_enter(chip, desc);
 	for (;;) {
 		/* Reading ISR acks pending (edge triggered) GPIO interrupts.
-		 * When there none are pending, we're finished unless we need
+		 * When there are none pending, we're finished unless we need
 		 * to process multiple banks (like ID_PIOCDE on sam9263).
 		 */
 		isr = readl_relaxed(pio + PIO_ISR) & readl_relaxed(pio + PIO_IMR);
@@ -1505,7 +1505,7 @@ static int at91_gpio_of_irq_setup(struct device_node *node,
 		prev = gpio_chips[at91_gpio->pioc_idx - 1];
 
 	/* The top level handler handles one bank of GPIOs, except
-	 * on some SoC it can handles up to three...
+	 * on some SoC it can handle up to three...
 	 * We only set up the handler for the first of the list.
 	 */
 	if (prev && prev->next == at91_gpio)
-- 
1.8.3.2

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/