Re: [PATCH] regmap: irq: Allow using zero value for ack_base
From: Alexander Shiyan
Date: Sun Dec 15 2013 - 04:52:14 EST
> On 12/15/2013 10:36 AM, Alexander Shiyan wrote:
> > In some cases, clear interrupt register may be at address 0.
> > This patch allows to use such configurations by adding additional
> > configuration bit to indicate this.
> >
> > Signed-off-by: Alexander Shiyan <shc_work@xxxxxxx>
> > ---
> > drivers/base/regmap/regmap-irq.c | 6 +++---
> > include/linux/regmap.h | 5 ++++-
> > 2 files changed, 7 insertions(+), 4 deletions(-)
...
> > diff --git a/include/linux/regmap.h b/include/linux/regmap.h
> > index e559078..3a36f61 100644
> > --- a/include/linux/regmap.h
> > +++ b/include/linux/regmap.h
...
> > @@ -520,6 +522,7 @@ struct regmap_irq_chip {
> > unsigned int irq_reg_stride;
> > bool init_ack_masked:1;
> > bool mask_invert:1;
> > + bool use_ack:1;
> I think this will break something. Better use 0 as default value.
> Reason I think so, is because in the above code you effectively add a new
> possibility for most code to run.
This is not a default value but bit-size of this field.
---
èº{.nÇ+·®+%Ëlzwm
ébëæìr¸zX§»®w¥{ayºÊÚë,j¢f£¢·hàz¹®w¥¢¸¢·¦j:+v¨wèjØm¶ÿ¾«êçzZ+ùÝj"ú!¶iOæ¬z·vØ^¶m§ÿðÃnÆàþY&