Re: [PATCH 2/2] serial: pl011: Move uart_register_driver call to device probe

[Russell King - ARM Linux]

On Thu, Feb 13, 2014 at 10:12:16AM -0800, Greg KH wrote:
> On Mon, Jan 20, 2014 at 10:04:15AM +0000, Russell King - ARM Linux wrote:
> > On Mon, Jan 20, 2014 at 02:32:35PM +0530, Tushar Behera wrote:
> > > uart_register_driver call binds the driver to a specific device
> > > node through tty_register_driver call. This should typically happen
> > > during device probe call.
> > > 
> > > In a multiplatform scenario, it is possible that multiple serial
> > > drivers are part of the kernel. Currently the driver registration fails
> > > if multiple serial drivers with same default major/minor numbers are
> > > included in the kernel.
> > > 
> > > A typical case is observed with amba-pl011 and samsung-uart drivers.
> > 
> > NAK.  There should not be any other driver using amba-pl011's device numbers.
> 
> I agree, but there is.  And because of that, moving the registration to
> the probe call fixes the issue with building a kernel with all of the
> drivers built into them, so I'm going to take both of these patches, as
> it does solve that problem, while still allowing the device number
> collision to happen.

So what happens when two _devices_ are probed by this driver at the same
time?

-- 
FTTC broadband for 0.8mile line: 5.8Mbps down 500kbps up.  Estimation
in database were 13.1 to 19Mbit for a good line, about 7.5+ for a bad.
Estimate before purchase was "up to 13.2Mbit".
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/