Re: [E1000-devel] e1000e 0000:00:19.0 eth0: Hardware Error

[Borislav Petkov]

Hi guys,

let me answer to all of you here:

On Thu, Apr 10, 2014 at 03:45:41PM +0000, Ertman, DavidX M wrote:
> Could you also provide some information about the configuration
> of the system when this happens?

AFAIR, this happens when I stick the network cable in. I'll pay
attention to the exact moment when this happens in the future and report
back.

> Do you have Runtime Power Management configured
> in the kernel and enabled? (echo auto >
> /sys/devices/pci0000\:00/0000\:00\:19.0/power/control)

Yes. I normally run powertop when the machine goes up after a reboot and
set all tunables to "Good". The above is one of them.

> Is the network cable in and link is up?

Yes, as I mentioned, there is a very high chance that it happens when I
plug in the network cable. But I'll need to confirm that.

> Is anything happening to the link partner (going up and down,
> connecting and disconnecting)?

Not that I know of - the partner is a 8-port switch where other machines
are connected. Their connection is fine AFAICT.

> We also need to know what part you're using. "lspci | grep Ethernet"
> should narrow that down.

> What kind of system (platform) is this happening on? It's a LOM
> correct? Can you run 'lspci -vvv' and output the results?

Machine is Thinkpad x230, I'm attaching full lspci -vvv -xxxx output
with PCI config space dump, hth.

Thanks guys.

-- 
Regards/Gruss,
    Boris.

Sent from a fat crate under my desk. Formatting is fine.
--

Attachment: lspci.gz
Description: Binary data