Re: [PATCH v10 4/4] usb: ehci-exynos: Change to use phy provided by the generic phy framework

From: Tomasz Figa
Date: Thu May 01 2014 - 13:17:13 EST


Hi Vivek,

I believe the same comments as for the patch for ohci-exynos apply for this patch as well.

Best regards,
Tomasz

On 30.04.2014 07:19, Vivek Gautam wrote:
From: Kamil Debski <k.debski@xxxxxxxxxxx>

Add the phy provider, supplied by new Exynos-usb2phy using
Generic phy framework.
Keeping the support for older USB phy intact right now, in order
to prevent any functionality break in absence of relevant
device tree side change for ehci-exynos.
Once we move to new phy in the device nodes for ehci, we can
remove the support for older phys.

Signed-off-by: Kamil Debski <k.debski@xxxxxxxxxxx>
[gautam.vivek@xxxxxxxxxxx: Addressed review comments from mailing list]
[gautam.vivek@xxxxxxxxxxx: Kept the code for old usb-phy, and just
added support for new exynos5-usb2phy in generic phy framework]
[gautam.vivek@xxxxxxxxxxx: Edited the commit message]
Signed-off-by: Vivek Gautam <gautam.vivek@xxxxxxxxxxx>
Cc: Jingoo Han <jg1.han@xxxxxxxxxxx>
Cc: Alan Stern <stern@xxxxxxxxxxxxxxxxxxx>
---

Changes from v9:
- Calling usb_phy_shutdown() when exynos_ehci_phy_enable() is failing.
- Made exynos_ehci_phy_disable() return void, since its return value
did not serve any purpose.
- Calling clk_disable_unprepare() in exynos_ehci_resume() when
exynos_ehci_phy_enable() is failed.

.../devicetree/bindings/usb/exynos-usb.txt | 18 +++
drivers/usb/host/ehci-exynos.c | 144 +++++++++++++++++---
2 files changed, 142 insertions(+), 20 deletions(-)

diff --git a/Documentation/devicetree/bindings/usb/exynos-usb.txt b/Documentation/devicetree/bindings/usb/exynos-usb.txt
index a90c973..126a7a9 100644
--- a/Documentation/devicetree/bindings/usb/exynos-usb.txt
+++ b/Documentation/devicetree/bindings/usb/exynos-usb.txt
@@ -12,6 +12,15 @@ Required properties:
- interrupts: interrupt number to the cpu.
- clocks: from common clock binding: handle to usb clock.
- clock-names: from common clock binding: Shall be "usbhost".
+ - port: if in the SoC there are EHCI phys, they should be listed here.
+ One phy per port. Each port should have following entries:
+ - reg: port number on EHCI controller, e.g
+ On Exynos5250, port 0 is USB2.0 otg phy
+ port 1 is HSIC phy0
+ port 2 is HSIC phy1
+ - phys: from the *Generic PHY* bindings; specifying phy used by port.
+ - phy-names: from the *Generic PHY* bindings; specifying name of phy
+ used by the port.

Optional properties:
- samsung,vbus-gpio: if present, specifies the GPIO that
@@ -27,6 +36,15 @@ Example:

clocks = <&clock 285>;
clock-names = "usbhost";
+
+ #address-cells = <1>;
+ #size-cells = <0>;
+ port@0 {
+ reg = <0>;
+ phys = <&usb2phy 1>;
+ phy-names = "host";
+ status = "disabled";
+ };
};

OHCI
diff --git a/drivers/usb/host/ehci-exynos.c b/drivers/usb/host/ehci-exynos.c
index 4d763dc..931cfc8 100644
--- a/drivers/usb/host/ehci-exynos.c
+++ b/drivers/usb/host/ehci-exynos.c
@@ -19,6 +19,7 @@
#include <linux/module.h>
#include <linux/of.h>
#include <linux/of_gpio.h>
+#include <linux/phy/phy.h>
#include <linux/platform_device.h>
#include <linux/usb/phy.h>
#include <linux/usb/samsung_usb_phy.h>
@@ -42,14 +43,119 @@
static const char hcd_name[] = "ehci-exynos";
static struct hc_driver __read_mostly exynos_ehci_hc_driver;

+#define PHY_NUMBER 3
struct exynos_ehci_hcd {
struct clk *clk;
struct usb_phy *phy;
struct usb_otg *otg;
+ struct phy *phy_g[PHY_NUMBER];
};

#define to_exynos_ehci(hcd) (struct exynos_ehci_hcd *)(hcd_to_ehci(hcd)->priv)

+static int exynos_ehci_get_phy(struct device *dev,
+ struct exynos_ehci_hcd *exynos_ehci)
+{
+ struct device_node *child;
+ struct phy *phy;
+ int phy_number;
+ int ret = 0;
+
+ exynos_ehci->phy = devm_usb_get_phy(dev, USB_PHY_TYPE_USB2);
+ if (IS_ERR(exynos_ehci->phy)) {
+ ret = PTR_ERR(exynos_ehci->phy);
+ /* This is the case when PHY config is disabled */
+ if (ret == -ENXIO || ret == -ENODEV) {
+ dev_dbg(dev, "Failed to get usb2 phy\n");
+ exynos_ehci->phy = NULL;
+ ret = 0;
+ } else if (ret == -EPROBE_DEFER) {
+ goto fail_phy;
+ } else {
+ dev_err(dev, "no usb2 phy configured\n");
+ goto fail_phy;
+ }
+ } else {
+ exynos_ehci->otg = exynos_ehci->phy->otg;
+ }
+
+ for_each_available_child_of_node(dev->of_node, child) {
+ ret = of_property_read_u32(child, "reg", &phy_number);
+ if (ret) {
+ dev_err(dev, "Failed to parse device tree\n");
+ of_node_put(child);
+ goto fail_phy;
+ }
+ if (phy_number >= PHY_NUMBER) {
+ dev_err(dev, "Invalid number of PHYs\n");
+ of_node_put(child);
+ ret = -EINVAL;
+ goto fail_phy;
+ }
+ phy = devm_of_phy_get(dev, child, 0);
+ of_node_put(child);
+ if (IS_ERR(phy)) {
+ ret = PTR_ERR(phy);
+ /* This is the case when PHY config is disabled */
+ if (ret == -ENOSYS || ret == -ENODEV) {
+ dev_dbg(dev, "Failed to get usb2 phy\n");
+ phy = NULL;
+ ret = 0;
+ } else if (ret == -EPROBE_DEFER) {
+ goto fail_phy;
+ } else {
+ dev_err(dev, "no usb2 phy configured\n");
+ goto fail_phy;
+ }
+ }
+ exynos_ehci->phy_g[phy_number] = phy;
+ }
+
+fail_phy:
+ return ret;
+}
+
+static int exynos_ehci_phy_enable(struct device *dev)
+{
+ struct usb_hcd *hcd = dev_get_drvdata(dev);
+ struct exynos_ehci_hcd *exynos_ehci = to_exynos_ehci(hcd);
+ int i;
+ int ret = 0;
+
+ if (exynos_ehci->phy) {
+ ret = usb_phy_init(exynos_ehci->phy);
+ if (ret)
+ return ret;
+ }
+
+ for (i = 0; ret == 0 && i < PHY_NUMBER; i++)
+ if (exynos_ehci->phy_g[i])
+ ret = phy_power_on(exynos_ehci->phy_g[i]);
+ if (ret) {
+ for (i--; i >= 0; i--)
+ if (exynos_ehci->phy_g[i])
+ phy_power_off(exynos_ehci->phy_g[i]);
+ if (exynos_ehci->phy)
+ usb_phy_shutdown(exynos_ehci->phy);
+ }
+
+ return ret;
+}
+
+static void exynos_ehci_phy_disable(struct device *dev)
+{
+ struct usb_hcd *hcd = dev_get_drvdata(dev);
+ struct exynos_ehci_hcd *exynos_ehci = to_exynos_ehci(hcd);
+ int i;
+
+ if (exynos_ehci->phy)
+ usb_phy_shutdown(exynos_ehci->phy);
+
+ for (i = 0; i < PHY_NUMBER; i++)
+ if (exynos_ehci->phy_g[i])
+ phy_power_off(exynos_ehci->phy_g[i]);
+}
+
static void exynos_setup_vbus_gpio(struct device *dev)
{
int err;
@@ -74,7 +180,6 @@ static int exynos_ehci_probe(struct platform_device *pdev)
struct usb_hcd *hcd;
struct ehci_hcd *ehci;
struct resource *res;
- struct usb_phy *phy;
int irq;
int err;

@@ -101,15 +206,9 @@ static int exynos_ehci_probe(struct platform_device *pdev)
"samsung,exynos5440-ehci"))
goto skip_phy;

- phy = devm_usb_get_phy(&pdev->dev, USB_PHY_TYPE_USB2);
- if (IS_ERR(phy)) {
- usb_put_hcd(hcd);
- dev_warn(&pdev->dev, "no platform data or transceiver defined\n");
- return -EPROBE_DEFER;
- } else {
- exynos_ehci->phy = phy;
- exynos_ehci->otg = phy->otg;
- }
+ err = exynos_ehci_get_phy(&pdev->dev, exynos_ehci);
+ if (err)
+ goto fail_clk;

skip_phy:

@@ -151,8 +250,11 @@ skip_phy:
if (exynos_ehci->otg)
exynos_ehci->otg->set_host(exynos_ehci->otg, &hcd->self);

- if (exynos_ehci->phy)
- usb_phy_init(exynos_ehci->phy);
+ err = exynos_ehci_phy_enable(&pdev->dev);
+ if (err) {
+ dev_err(&pdev->dev, "Failed to enable USB phy\n");
+ goto fail_io;
+ }

ehci = hcd_to_ehci(hcd);
ehci->caps = hcd->regs;
@@ -172,8 +274,7 @@ skip_phy:
return 0;

fail_add_hcd:
- if (exynos_ehci->phy)
- usb_phy_shutdown(exynos_ehci->phy);
+ exynos_ehci_phy_disable(&pdev->dev);
fail_io:
clk_disable_unprepare(exynos_ehci->clk);
fail_clk:
@@ -191,8 +292,7 @@ static int exynos_ehci_remove(struct platform_device *pdev)
if (exynos_ehci->otg)
exynos_ehci->otg->set_host(exynos_ehci->otg, &hcd->self);

- if (exynos_ehci->phy)
- usb_phy_shutdown(exynos_ehci->phy);
+ exynos_ehci_phy_disable(&pdev->dev);

clk_disable_unprepare(exynos_ehci->clk);

@@ -217,8 +317,7 @@ static int exynos_ehci_suspend(struct device *dev)
if (exynos_ehci->otg)
exynos_ehci->otg->set_host(exynos_ehci->otg, &hcd->self);

- if (exynos_ehci->phy)
- usb_phy_shutdown(exynos_ehci->phy);
+ exynos_ehci_phy_disable(dev);

clk_disable_unprepare(exynos_ehci->clk);

@@ -229,14 +328,19 @@ static int exynos_ehci_resume(struct device *dev)
{
struct usb_hcd *hcd = dev_get_drvdata(dev);
struct exynos_ehci_hcd *exynos_ehci = to_exynos_ehci(hcd);
+ int ret;

clk_prepare_enable(exynos_ehci->clk);

if (exynos_ehci->otg)
exynos_ehci->otg->set_host(exynos_ehci->otg, &hcd->self);

- if (exynos_ehci->phy)
- usb_phy_init(exynos_ehci->phy);
+ ret = exynos_ehci_phy_enable(dev);
+ if (ret) {
+ dev_err(dev, "Failed to enable USB phy\n");
+ clk_disable_unprepare(exynos_ehci->clk);
+ return ret;
+ }

/* DMA burst Enable */
writel(EHCI_INSNREG00_ENABLE_DMA_BURST, EHCI_INSNREG00(hcd->regs));

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/