Re: [PATCH] imx6 PCI Host initialisation order

[Shawn Guo]

Hi Raymond,

It seems that there is already a similar patch [1] from Tim floating
on the list.

Shawn

[1] http://www.spinics.net/lists/linux-pci/msg33520.html

On Mon, Sep 08, 2014 at 11:10:37AM +0200, Raymond van der Rots wrote:
> Hi,
> 
> The imx6dl on our hardware board frequently had problems bringing up the PCI link, with or without peripherals connected. I found these issues to be due to the initialisation order of the PCI Host.
> 
> The host driver first enables the phy, and then enables its clocks. However, according to the reference manual (IMX6SDLRM, page 2033):
> > The phy_ref_ssp_en signal must remain deasserted until the reference clock is running at the appropriate frequency, at which point phy_ref_ssp_en can be asserted.
> 
> 
> Which implies that the clocks should be brought up first, after which the peripheral should be enabled.
> This patch changes that initialisation order.
> 
> I do not have other hardware with an imx6dl, so this patch has only been tested on our board. Could someone confirm that this is more technically correct or improves behaviour?
> 
> Signed-off-by: Raymond van der Rots <raymond@xxxxxxxxxxxxxxxxxxx>
> ---
> diff --git a/drivers/pci/host/pci-imx6.c b/drivers/pci/host/pci-imx6.c
> index a568efa..17c35b4 100644
> --- a/drivers/pci/host/pci-imx6.c
> +++ b/drivers/pci/host/pci-imx6.c
> @@ -228,11 +228,6 @@ static int imx6_pcie_deassert_core_reset(struct pcie_port *pp)
>  	struct imx6_pcie *imx6_pcie = to_imx6_pcie(pp);
>  	int ret;
>  
> -	regmap_update_bits(imx6_pcie->iomuxc_gpr, IOMUXC_GPR1,
> -			IMX6Q_GPR1_PCIE_TEST_PD, 0 << 18);
> -	regmap_update_bits(imx6_pcie->iomuxc_gpr, IOMUXC_GPR1,
> -			IMX6Q_GPR1_PCIE_REF_CLK_EN, 1 << 16);
> -
>  	ret = clk_prepare_enable(imx6_pcie->pcie_phy);
>  	if (ret) {
>  		dev_err(pp->dev, "unable to enable pcie_phy clock\n");
> @@ -254,6 +249,11 @@ static int imx6_pcie_deassert_core_reset(struct pcie_port *pp)
>  	/* allow the clocks to stabilize */
>  	usleep_range(200, 500);
>  
> +	regmap_update_bits(imx6_pcie->iomuxc_gpr, IOMUXC_GPR1,
> +			IMX6Q_GPR1_PCIE_TEST_PD, 0 << 18);
> +	regmap_update_bits(imx6_pcie->iomuxc_gpr, IOMUXC_GPR1,
> +			IMX6Q_GPR1_PCIE_REF_CLK_EN, 1 << 16);
> +
>  	/* Some boards don't have PCIe reset GPIO. */
>  	if (gpio_is_valid(imx6_pcie->reset_gpio)) {
>  		gpio_set_value(imx6_pcie->reset_gpio, 0);
> 
> 
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/