Re: [PATCH V2 1/2] pinctrl: exynos: Add BUS1 pin controller for exynos7
From: Tomasz Figa
Date: Mon Dec 01 2014 - 11:09:08 EST
Please see my comments below.
2014-11-24 22:02 GMT+09:00 Vivek Gautam <gautam.vivek@xxxxxxxxxxx>:
> USB and Power regulator on Exynos7 require gpios available
> in BUS1 pin controller block.
> So adding the BUS1 pinctrl support.
> Signed-off-by: Naveen Krishna Ch <naveenkrishna.ch@xxxxxxxxx>
> Signed-off-by: Vivek Gautam <gautam.vivek@xxxxxxxxxxx>
> Cc: Linus Walleij <linus.walleij@xxxxxxxxxx>
> This patch was part of series:
> "[PATCH 00/11] Exynos7: Adding USB 3.0 support"
> Changes since V1:
> - Added support for all pin banks which are part of BUS1 pin controller.
> drivers/pinctrl/samsung/pinctrl-exynos.c | 19 +++++++++++++++++++
> 1 file changed, 19 insertions(+)
I have missed this with previous patch, but DT bindings documentation
should list all aliases for all supported compatible strings, because
they are required for correct operation. There is a small section
about aliases in  already, so please add there information about
aliases for Exynos7 pin controllers along with their names, e.g.
Aliases for controllers compatible with "samsung,exynos7-pinctrl":
- pinctrl0: pin controller of ALIVE block,
- pinctrl1: pin controller of BUS0 block,
- pinctrl8: pin controller of BUS1 block.
I guess you can do this in separate patch or respin this one with this added.
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/