Re: [PATCH v3] sbs-battery: add option to always register battery

[Sebastian Reichel]

Hi Frans,

On Wed, Jun 10, 2015 at 02:16:56PM +0200, Frans Klaver wrote:
> Commit a22b41a31e53 ("sbs-battery: Probe should try talking to the
> device") introduced a step in probing the SBS battery, that tries to
> talk to the device before actually registering it, saying:
> 
>     this driver doesn't actually try talking to the device at probe
>     time, so if it's incorrectly configured in the device tree or
>     platform data (or if the battery has been removed from the system),
>     then probe will succeed and every access will sit there and time
>     out. The end result is a possibly laggy system that thinks it has a
>     battery but can never read status, which isn't very useful.
> 
> Which is of course reasonable. However, it is also very well possible
> for a device to boot up on wall-power and be connected to a battery
> later on. This is a scenario that the driver supported before said patch
> was applied, and even easily achieved by booting up with the battery
> attached and removing it later on. sbs-battery's 'present' sysfs file
> can be used to determine if the device is available or not.
> 
> So with automated device detection lacking for now, in some cases it is
> possible that one wants to register a battery, even if none are attached
> at the moment. To facilitate this, add a module parameter that can be
> used to configure forced loading module loading time. If set, the battery
> will always be registered without checking the sanity of the connection.

Thanks, queued.

Please make sure to send patches based upon the correct branches
though. Your branch did not yet contain 297d716.

-- Sebastian

Attachment: signature.asc
Description: Digital signature