[PATCH 08/11] ARM: DTS: dra72-evm: Add gpio hog for vin6_sel_s0 to select audio

From: Peter Ujfalusi
Date: Mon Aug 24 2015 - 03:21:45 EST


The GPIO expander's p1 on i2c5 bus 0x26 address is used for selecting
between audio and VIN6 functionality. For VIN6 use an add on card is
needed while audio is present on the board itself.
Select the audio functionality over the VIN6 in the dts file.

Signed-off-by: Peter Ujfalusi <peter.ujfalusi@xxxxxx>
---
arch/arm/boot/dts/dra72-evm.dts | 15 +++++++++++++++
1 file changed, 15 insertions(+)

diff --git a/arch/arm/boot/dts/dra72-evm.dts b/arch/arm/boot/dts/dra72-evm.dts
index ac3a29483791..33be5c64bda3 100644
--- a/arch/arm/boot/dts/dra72-evm.dts
+++ b/arch/arm/boot/dts/dra72-evm.dts
@@ -119,6 +119,13 @@
>;
};

+ i2c5_pins: pinmux_i2c5_pins {
+ pinctrl-single,pins = <
+ 0x2b4 (PIN_INPUT | MUX_MODE10) /* mcasp1_axr0.i2c5_sda */
+ 0x2b8 (PIN_INPUT | MUX_MODE10) /* mcasp1_axr1.i2c5_scl */
+ >;
+ };
+
nand_default: nand_default {
pinctrl-single,pins = <
0x0 (PIN_INPUT | MUX_MODE0) /* gpmc_ad0 */
@@ -389,6 +396,14 @@
* VIN6_SEL_S0 is low, thus selecting McASP3 over VIN6
*/
lines-initial-states = <0x0f2b>;
+
+ p1 {
+ /* vin6_sel_s0: high: VIN6, low: audio */
+ gpio-hog;
+ gpios = <1 GPIO_ACTIVE_HIGH>;
+ output-low;
+ line-name = "vin6_sel_s0";
+ };
};
};

--
2.5.0

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/