Re: [PATCH v3 1/5] Documentation: add DT bindings for ARM SCPI sensors

[Jon Medhurst (Tixy)]

On Mon, 2015-09-14 at 15:38 +0100, Punit Agrawal wrote:
> Mark Rutland <mark.rutland@xxxxxxx> writes:
> 
> >> >> +Sensor bindings for the sensors based on SCPI Message Protocol
> >> >> +--------------------------------------------------------------
> >> >> +SCPI provides an API to access the various sensors on the SoC.
> >> >> +
> >> >> +Required properties:
> >> >> +- compatible : should be "arm,scpi-sensors".
> >> >> +- #thermal-sensor-cells: should be set to 1. This property follows the
> >> >> +			 thermal device tree bindings[2].
> >> >
> >> > You need to specify what the valid values for this cell are.
> >> 
> >> The enumeration depends on the number of sensors exported by SCP
> >> firmware - which is platform dependent. I could add add something like
> >> if you think that is helpful -
> >> 
> >> "Valid cell value is a number between 0..n-1, where n is the number
> >> of sensors exported by SCP firmware."
> >
> > Can the FW identifer space have holes? Or are they always contiguous?
> 
> The way the SCP interface is defined, the sensor identifiers are
> contiguous,

Is there any documentation other than DUI0922A? [1] From what I can seen
that just says it's a 16-bit value and doesn't put any particular
constraints on its value.

[1] http://community.arm.com/servlet/JiveServlet/download/8401-40-18262/DUI0922A_scp_message_interface.pdf

-- 
Tixy

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/