Re: [PATCH RESEND 5/5] mfd: arizona: Update DT doc for new mic detection bindings

[Chanwoo Choi]

Hi Charles,

On 2015ë 09ì 11ì 16:52, Chanwoo Choi wrote:
> On 2015ë 09ì 09ì 17:34, Charles Keepax wrote:
>> Signed-off-by: Charles Keepax <ckeepax@xxxxxxxxxxxxxxxxxxxxxxxxxxx>
>> ---
>>  Documentation/devicetree/bindings/mfd/arizona.txt |   21 +++++++++++++++++++++
>>  include/dt-bindings/mfd/arizona.h                 |    5 +++++
>>  2 files changed, 26 insertions(+), 0 deletions(-)
>>
>> diff --git a/Documentation/devicetree/bindings/mfd/arizona.txt b/Documentation/devicetree/bindings/mfd/arizona.txt
>> index a8fee60..b98a11b 100644
>> --- a/Documentation/devicetree/bindings/mfd/arizona.txt
>> +++ b/Documentation/devicetree/bindings/mfd/arizona.txt
>> @@ -73,6 +73,27 @@ Optional properties:
>>      If this node is not mentioned or if the value is unknown, then
>>      headphone detection mode is set to HPDETL.
>>  
>> +  - wlf,micd-software-compare : Use a software comparison to determine mic
>> +    presence
>> +  - wlf,micd-detect-debounce : Additional software microphone detection
>> +    debounce specified in milliseconds.
>> +  - wlf,micd-pol-gpio : GPIO specifier for the GPIO controlling the headset
>> +    polarity if one exists.
>> +  - wlf,micd-bias-start-time : Time allowed for MICBIAS to startup prior to
>> +    performing microphone detection, specified as per the ARIZONA_MICD_TIME_XXX
>> +    defines.
>> +  - wlf,micd-rate : Delay between successive microphone detection measurements,
>> +    specified as per the ARIZONA_MICD_TIME_XXX defines.
>> +  - wlf,micd-dbtime : Microphone detection hardware debounces specified as the
>> +    number of measurements to take, valid values being 2 and 4.
>> +  - wlf,micd-timeout : Timeout for microphone detection, specified in
>> +    milliseconds.
>> +  - wlf,micd-force-micbias : Force MICBIAS continuously on during microphone
>> +    detection.
>> +
>> +  - wlf,gpsw : Settings for the general purpose switch, set as one of the
>> +    ARIZONA_GPSW_XXX defines.
>> +
>>    - DCVDD-supply, MICVDD-supply : Power supplies, only need to be specified if
>>      they are being externally supplied. As covered in
>>      Documentation/devicetree/bindings/regulator/regulator.txt
>> diff --git a/include/dt-bindings/mfd/arizona.h b/include/dt-bindings/mfd/arizona.h
>> index c40f665..dedf46f 100644
>> --- a/include/dt-bindings/mfd/arizona.h
>> +++ b/include/dt-bindings/mfd/arizona.h
>> @@ -110,4 +110,9 @@
>>  #define ARIZONA_ACCDET_MODE_HPM 4
>>  #define ARIZONA_ACCDET_MODE_ADC 7
>>  
>> +#define ARIZONA_GPSW_OPEN           0
>> +#define ARIZONA_GPSW_CLOSED         1
>> +#define ARIZONA_GPSW_CLAMP_ENABLED  2
>> +#define ARIZONA_GPSW_CLAMP_DISABLED 3
>> +
>>  #endif
>>
> 
> Reviewed-by: Chanwoo Choi <cw00.choi@xxxxxxxxxxx>
> 
> You may need the ack message by DT maintainer.

I think that you need to add the patch description for this patch.

Thanks,
Chanwoo Choi

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/