Re: [PATCH v3] mfd: cros ec: Lock the SPI bus while holding chipselect

[Lee Jones]

On Wed, 25 Nov 2015, Nicolas Boichat wrote:

> cros_ec_cmd_xfer_spi and cros_ec_pkt_xfer_spi generally work like
> this:
>  - Pull CS down (active), wait a bit, then send a command
>  - Wait for response (multiple requests)
>  - Wait a while, pull CS up (inactive)
> 
> These operations, individually, lock the SPI bus, but there is
> nothing preventing the SPI framework from interleaving messages
> intended for other devices as the bus is unlocked in between.
> 
> This is a problem as the EC expects CS to be held low for the
> whole duration.
> 
> Solution: Lock the SPI bus during the whole transaction, to make
> sure that no other messages can be interleaved.
> 
> Signed-off-by: Nicolas Boichat <drinkcat@xxxxxxxxxxxx>
> ---
> 
> v2: Move bus_unlock earlier in the functions.
> v3: Remove comments.
> 
> Applies on top on linux-next/master (20151124)
> 
>  drivers/mfd/cros_ec_spi.c | 30 ++++++++++++++++++------------
>  1 file changed, 18 insertions(+), 12 deletions(-)

Acked-by: Lee Jones <lee.jones@xxxxxxxxxx>

> diff --git a/drivers/mfd/cros_ec_spi.c b/drivers/mfd/cros_ec_spi.c
> index 6a0f6ec..d6af52d 100644
> --- a/drivers/mfd/cros_ec_spi.c
> +++ b/drivers/mfd/cros_ec_spi.c
> @@ -113,7 +113,7 @@ static int terminate_request(struct cros_ec_device *ec_dev)
>  	trans.delay_usecs = ec_spi->end_of_msg_delay;
>  	spi_message_add_tail(&trans, &msg);
>  
> -	ret = spi_sync(ec_spi->spi, &msg);
> +	ret = spi_sync_locked(ec_spi->spi, &msg);
>  
>  	/* Reset end-of-response timer */
>  	ec_spi->last_transfer_ns = ktime_get_ns();
> @@ -147,7 +147,7 @@ static int receive_n_bytes(struct cros_ec_device *ec_dev, u8 *buf, int n)
>  
>  	spi_message_init(&msg);
>  	spi_message_add_tail(&trans, &msg);
> -	ret = spi_sync(ec_spi->spi, &msg);
> +	ret = spi_sync_locked(ec_spi->spi, &msg);
>  	if (ret < 0)
>  		dev_err(ec_dev->dev, "spi transfer failed: %d\n", ret);
>  
> @@ -391,10 +391,10 @@ static int cros_ec_pkt_xfer_spi(struct cros_ec_device *ec_dev,
>  	}
>  
>  	rx_buf = kzalloc(len, GFP_KERNEL);
> -	if (!rx_buf) {
> -		ret = -ENOMEM;
> -		goto exit;
> -	}
> +	if (!rx_buf)
> +		return -ENOMEM;
> +
> +	spi_bus_lock(ec_spi->spi->master);
>  
>  	/*
>  	 * Leave a gap between CS assertion and clocking of data to allow the
> @@ -414,7 +414,7 @@ static int cros_ec_pkt_xfer_spi(struct cros_ec_device *ec_dev,
>  	trans.len = len;
>  	trans.cs_change = 1;
>  	spi_message_add_tail(&trans, &msg);
> -	ret = spi_sync(ec_spi->spi, &msg);
> +	ret = spi_sync_locked(ec_spi->spi, &msg);
>  
>  	/* Get the response */
>  	if (!ret) {
> @@ -440,6 +440,9 @@ static int cros_ec_pkt_xfer_spi(struct cros_ec_device *ec_dev,
>  	}
>  
>  	final_ret = terminate_request(ec_dev);
> +
> +	spi_bus_unlock(ec_spi->spi->master);
> +
>  	if (!ret)
>  		ret = final_ret;
>  	if (ret < 0)
> @@ -520,10 +523,10 @@ static int cros_ec_cmd_xfer_spi(struct cros_ec_device *ec_dev,
>  	}
>  
>  	rx_buf = kzalloc(len, GFP_KERNEL);
> -	if (!rx_buf) {
> -		ret = -ENOMEM;
> -		goto exit;
> -	}
> +	if (!rx_buf)
> +		return -ENOMEM;
> +
> +	spi_bus_lock(ec_spi->spi->master);
>  
>  	/* Transmit phase - send our message */
>  	debug_packet(ec_dev->dev, "out", ec_dev->dout, len);
> @@ -534,7 +537,7 @@ static int cros_ec_cmd_xfer_spi(struct cros_ec_device *ec_dev,
>  	trans.cs_change = 1;
>  	spi_message_init(&msg);
>  	spi_message_add_tail(&trans, &msg);
> -	ret = spi_sync(ec_spi->spi, &msg);
> +	ret = spi_sync_locked(ec_spi->spi, &msg);
>  
>  	/* Get the response */
>  	if (!ret) {
> @@ -560,6 +563,9 @@ static int cros_ec_cmd_xfer_spi(struct cros_ec_device *ec_dev,
>  	}
>  
>  	final_ret = terminate_request(ec_dev);
> +
> +	spi_bus_unlock(ec_spi->spi->master);
> +
>  	if (!ret)
>  		ret = final_ret;
>  	if (ret < 0)

-- 
Lee Jones
Linaro STMicroelectronics Landing Team Lead
Linaro.org â Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/