Re: [RFC PATCH 2/4] mmc: core: implement enhanced strobe support

[Shawn Lin]

Hi Adrian,

On 2016/3/3 21:37, Adrian Hunter wrote:
> On 03/03/16 04:36, Shawn Lin wrote:
> > Controllers use data strobe line to latch data from devices
> > under hs400 mode, but not for cmd line. So from emmc 5.1, JEDEC
> > introduces enhanced strobe mode for latching cmd response from
> > emmc devices to host controllers. This new feature is optional.
>
> As I currently understand it, HS400ES does not require tuning.
> Consequently you can go straight to HS400ES and do not need to do
> HS200 first.  If that is the case then more changes are needed.

That's the case, and it's already in my plan before I going to remove
"RFC" prefix. From my experience of developing emmc-device firmware, the
only reason we need tuning for HS200 before we switch it into HS400
is that although data-line can be latched by DS but the cmd-line is 
still in SDR mode when runing in HS400. With hs400-es setuped, tuning
and retune stuff is meaningless. ALl the SI should be guranteed by HW
design to regulate the PCB payload.


> Also it would be nice if the transfer mode displayed reflected enhanced
> strobe e.g.

Great idea! And maybe more thing should be done for core/debugfs.c
It seems to big change for init_card, so I need more time to split my
step for changing it to make the change will not do any side effect from
non-hs400es procedure. :)

Thanks.

> 	Currently
>
> 		mmc1: new HS400 MMC card at address 0001
>
> 	Change for enhance strobe supported
>
> 		mmc1: new HS400ES MMC card at address 0001
>
>
> --
> To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
> the body of a message to majordomo@xxxxxxxxxxxxxxx
> More majordomo info at  http://vger.kernel.org/majordomo-info.html