[RFC PATCH v2 1/4] Documentation: DT: net: Add Xilinx gmiitorgmii converter device tree binding documentation

[Kedareswara rao Appana]

Device-tree binding documentation for xilinx gmiitorgmii converter.

Signed-off-by: Kedareswara rao Appana <appanad@xxxxxxxxxx>
---
Changes for v2:
--> New patch.

 .../devicetree/bindings/net/xilinx_gmii2rgmii.txt  | 31 ++++++++++++++++++++++
 1 file changed, 31 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/net/xilinx_gmii2rgmii.txt

diff --git a/Documentation/devicetree/bindings/net/xilinx_gmii2rgmii.txt b/Documentation/devicetree/bindings/net/xilinx_gmii2rgmii.txt
new file mode 100644
index 0000000..d11e259
--- /dev/null
+++ b/Documentation/devicetree/bindings/net/xilinx_gmii2rgmii.txt
@@ -0,0 +1,31 @@
+* XILINX GMIITORGMII Converter Driver
+
+The Gigabit Media Independent Interface (GMII) to Reduced Gigabit Media
+Independent Interface (RGMII) core provides the RGMII between RGMII-compliant
+Ethernet physical media devices (PHY) and the Gigabit Ethernet controller.
+This core can be used in all three modes of operation(10/100/1000 Mb/s).
+The Management Data Input/Output (MDIO) interface is used to configure the
+Speed of operation. This core can switch dynamically between the three
+Different speed modes by configuring the conveter register through mdio write.
+
+The MDIO is a bus to which the PHY devices are connected.  For each
+device that exists on this bus, a child node should be created.  See
+the definition of the PHY node in booting-without-of.txt for an example
+of how to define a PHY.
+
+Required properties:
+  - compatible : Should be "xlnx,gmiitorgmii"
+  - reg : The ID number for the phy, usually a small integer
+
+Example:
+	mdio {
+                #address-cells = <1>;
+                #size-cells = <0>;
+		ethernet-phy@0 {
+			......
+		};
+                gmii_to_rgmii: gmii_to_rgmii@8 {
+                        compatible = "xlnx,gmiitorgmii";
+                        reg = <8>;
+                };
+        };
-- 
2.1.2