[PATCH v3 5/5] mm: enable CONFIG_MOVABLE_NODE on powerpc

[Reza Arbab]

To create a movable node, we need to hotplug all of its memory into
ZONE_MOVABLE.

Note that to do this, auto_online_blocks should be off. Since the memory
will first be added to the default zone, we must explicitly use
online_movable to online.

Because such a node contains no normal memory, can_online_high_movable()
will only allow us to do the onlining if CONFIG_MOVABLE_NODE is set.
Enable the use of this config option on PPC64 platforms.

Signed-off-by: Reza Arbab <arbab@xxxxxxxxxxxxxxxxxx>
---
 Documentation/kernel-parameters.txt | 2 +-
 mm/Kconfig                          | 2 +-
 2 files changed, 2 insertions(+), 2 deletions(-)

diff --git a/Documentation/kernel-parameters.txt b/Documentation/kernel-parameters.txt
index a4f4d69..3d8460d 100644
--- a/Documentation/kernel-parameters.txt
+++ b/Documentation/kernel-parameters.txt
@@ -2344,7 +2344,7 @@ bytes respectively. Such letter suffixes can also be entirely omitted.
 			that the amount of memory usable for all allocations
 			is not too small.
 
-	movable_node	[KNL,X86] Boot-time switch to enable the effects
+	movable_node	[KNL,X86,PPC] Boot-time switch to enable the effects
 			of CONFIG_MOVABLE_NODE=y. See mm/Kconfig for details.
 
 	MTD_Partition=	[MTD]
diff --git a/mm/Kconfig b/mm/Kconfig
index be0ee11..4b19cd3 100644
--- a/mm/Kconfig
+++ b/mm/Kconfig
@@ -153,7 +153,7 @@ config MOVABLE_NODE
 	bool "Enable to assign a node which has only movable memory"
 	depends on HAVE_MEMBLOCK
 	depends on NO_BOOTMEM
-	depends on X86_64
+	depends on X86_64 || PPC64
 	depends on NUMA
 	default n
 	help
-- 
1.8.3.1