Re: [PATCH 2/4] iio: hi8435: avoid garbage event at first enable

[Vladimir Barinov]

Hi Nikita,

On 19.05.2017 17:48, Nikita Yushchenko wrote:
> Currently, driver generates events for channels if new reading differs
> from previous one. This "previous value" is initialized to zero, which
> results into event if value is constant-one.
>
> Fix that by initializing "previous value" by reading at event enable
> time.
>
> This provides reliable sequence for userspace:
> - enable event,
> - AFTER THAT read current value,
> - AFTER THAT each event will correspond to change.
>
> Signed-off-by: Nikita Yushchenko <nikita.yoush@xxxxxxxxxxxxxxxxxx>
> ---
>   drivers/iio/adc/hi8435.c | 15 +++++++++++++--
>   1 file changed, 13 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/iio/adc/hi8435.c b/drivers/iio/adc/hi8435.c
> index cb8e6342eddf..45a92e3e8f2b 100644
> --- a/drivers/iio/adc/hi8435.c
> +++ b/drivers/iio/adc/hi8435.c
> @@ -141,10 +141,21 @@ static int hi8435_write_event_config(struct iio_dev *idev,
>   				     enum iio_event_direction dir, int state)
>   {
>   	struct hi8435_priv *priv = iio_priv(idev);
> +	int ret;
> +	u32 tmp;
> +
> +	if (state) {
> +		ret = hi8435_readl(priv, HI8435_SO31_0_REG, &tmp);
> +		if (ret < 0)
> +			return ret;
> +		if (tmp & BIT(chan->channel))
> +			priv->event_prev_val |= BIT(chan->channel);
> +		else
> +			priv->event_prev_val &= ~BIT(chan->channel);
>   
> -	priv->event_scan_mask &= ~BIT(chan->channel);
> -	if (state)
>   		priv->event_scan_mask |= BIT(chan->channel);
> +	} else
> +		priv->event_scan_mask &= ~BIT(chan->channel);
>   

This will race with hi8435_iio_push_event for priv->event_scan_mask.

Since you adding raw access then it is reasonable to initialize 
priv->event_prev_val in hi8435_read_raw.
Then use the following sequence for your application:
1. read raw value
2. enable events

Regards,
Vladimir