Re: linux-next: manual merge of the tty tree with the arm-soc tree

[Stephen Rothwell]

Hi all,

With the merge window opening, just a reminder that this conflict still
exists.

On Tue, 20 Jun 2017 13:52:42 +1000 Stephen Rothwell <sfr@xxxxxxxxxxxxxxxx> wrote:
>
> Today's linux-next merge of the tty tree got a conflict in:
> 
>   include/linux/platform_data/atmel.h
> 
> between commit:
> 
>   8a3d809373c6 ("ARM: at91: remove atmel_nand_data")
> 
> from the arm-soc tree and commit:
> 
>   92c8f7c0e109 ("tty/serial: atmel: make the driver DT only")
> 
> from the tty tree.
> 
> I fixed it up (see below) and can carry the fix as necessary. This
> is now fixed as far as linux-next is concerned, but any non trivial
> conflicts should be mentioned to your upstream maintainer when your tree
> is submitted for merging.  You may also want to consider cooperating
> with the maintainer of the conflicting tree to minimise any particularly
> complex conflicts.
> 
> -- 
> Cheers,
> Stephen Rothwell
> 
> diff --cc include/linux/platform_data/atmel.h
> index 70c5c766628e,d36bc8d17e97..000000000000
> --- a/include/linux/platform_data/atmel.h
> +++ b/include/linux/platform_data/atmel.h
> @@@ -7,8 -7,9 +7,6 @@@
>   #ifndef __ATMEL_H__
>   #define __ATMEL_H__
>   
> - #include <linux/serial.h>
>  -#include <linux/mtd/nand.h>
>  -#include <linux/mtd/partitions.h>
> --
>    /* Compact Flash */
>   struct at91_cf_data {
>   	int	irq_pin;		/* I/O IRQ */
> @@@ -21,23 -22,26 +19,14 @@@
>   #define AT91_IDE_SWAP_A0_A2	0x02
>   };
>   
> -  /* Serial */
> - struct atmel_uart_data {
> - 	int			num;		/* port num */
> - 	short			use_dma_tx;	/* use transmit DMA? */
> - 	short			use_dma_rx;	/* use receive DMA? */
> - 	void __iomem		*regs;		/* virt. base address, if any */
> - 	struct serial_rs485	rs485;		/* rs485 settings */
>  - /* NAND / SmartMedia */
>  -struct atmel_nand_data {
>  -	int		enable_pin;		/* chip enable */
>  -	int		det_pin;		/* card detect */
>  -	int		rdy_pin;		/* ready/busy */
>  -	u8		rdy_pin_active_low;	/* rdy_pin value is inverted */
>  -	u8		ale;			/* address line number connected to ALE */
>  -	u8		cle;			/* address line number connected to CLE */
>  -	u8		bus_width_16;		/* buswidth is 16 bit */
>  -	u8		ecc_mode;		/* ecc mode */
>  -	u8		on_flash_bbt;		/* bbt on flash */
>  -	struct mtd_partition *parts;
>  -	unsigned int	num_parts;
>  -	bool		has_dma;		/* support dma transfer */
>  -
>  -	/* default is false, only for at32ap7000 chip is true */
>  -	bool		need_reset_workaround;
> --};
> --
>   /* FIXME: this needs a better location, but gets stuff building again */
>  +#ifdef CONFIG_ATMEL_PM
>   extern int at91_suspend_entering_slow_clock(void);
>  +#else
>  +static inline int at91_suspend_entering_slow_clock(void)
>  +{
>  +	return 0;
>  +}
>  +#endif
>   
>   #endif /* __ATMEL_H__ */

-- 
Cheers,
Stephen Rothwell