Re: [PATCH] ARM: davinci_all_defconfig: enable CMA options

From: David Lechner
Date: Fri Sep 22 2017 - 12:43:37 EST


On 09/22/2017 11:24 AM, Suman Anna wrote:
Hi Sekhar,


On Thursday 21 September 2017 08:41 PM, Suman Anna wrote:
On 09/21/2017 09:43 AM, Sekhar Nori wrote:
On Wednesday 20 September 2017 11:31 PM, Suman Anna wrote:
Enable the CMA and DMA_CMA Kconfig options by default for
Davinci platforms. Davinci remoteproc driver is one of the
modules that depends on these options, and this allows the
driver to be made visible for selection with menuconfig.

Signed-off-by: Suman Anna <s-anna@xxxxxx>
---
Hi Sekhar,

Here's the patch that enables CMA as per your request. Patch based
on your v4.15/defconfig branch.

Applied! I guess you will be sending another patch enabling the
remoteproc driver itself?

Thanks. Well, one always needs a firmware image in their filesystem
without which enabling the driver is meaningless (it would fail). So was
not planning to enable it by default.

But the errors will show up only on DA850 LCDK where we have enabled the
DSP by default in DT because its an important usecase there. I think it
is important for users to see those errors.
(besides the usual benefits of having the module enabled to catch build
and runtime issues easily).

Yeah, DSP node is enabled only for DA850 LCDK among the DT-supported
boards, but I believe there are boards still using legacy boot, and it
shows up on those platforms as well. FYI, we do not have any rpmsg
drivers other than the kernel sample to make real usage of a booted
remoteproc. Anycase, if you still prefer this to be added, I don't mind.

regards
Suman


I am interested in using remoteproc on LEGO MINDSTORMS EV3 to implement I2C and UART in the PRU.