Re: [PATCH v3 2/5] mtd: spi-nor: cadence-quadspi: add a delay in write sequence

[Vignesh R]

On 9/24/2017 6:43 PM, Marek Vasut wrote:
> On 09/24/2017 02:33 PM, Vignesh R wrote:
>>
>>
>> On 9/24/2017 5:29 PM, Marek Vasut wrote:
>>> On 09/24/2017 12:59 PM, Vignesh R wrote:
>>>> As per 66AK2G02 TRM[1] SPRUHY8F section 11.15.5.3 Indirect Access
>>>> Controller programming sequence, a delay equal to couple of QSPI master
>>>> clock(~5ns) is required after setting CQSPI_REG_INDIRECTWR_START bit and
>>>> writing data to the flash. Introduce a quirk flag CQSPI_NEEDS_WR_DELAY
>>>> to handle this and set this flag for TI 66AK2G SoC.
>>>>
>>>> [1]http://www.ti.com/lit/ug/spruhy8f/spruhy8f.pdf
>>>>
>>>> Signed-off-by: Vignesh R <vigneshr@xxxxxx>
>>>
>>> Is this TI specific or is this controller property ? I wouldn't be
>>> surprised of the later ...
>>
>> I am not sure, there is no generic public documentation by cadence for
>> this IP. TI TRM clearly states this delay is required and I have
>> verified it practically that this delay is indeed needed.
>> But current user of this IP, socfpga does not seem to mention anything
>> about it. So, I guess its TI specific quirk.
> 
> OK, let's go with that then. I didn't observe any stability issues with
> SoCFPGA, but I didn't run the flash at 100s of MHz either. At what kind
> of frequencies does the quirk become relevant ?
> 

Actually, delay is tied to QSPI master clk rate(not SPI bus clk rate).
It runs at 384MHz. Changing SPI bus rate has no effect.

Regards
Vignesh

>>>
>>>> ---
>>>>
>>>> v3:
>>>> Fix build warnings reported by kbuild test bot.
>>>>
>>>>  drivers/mtd/spi-nor/cadence-quadspi.c | 27 ++++++++++++++++++++++++++-
>>>>  1 file changed, 26 insertions(+), 1 deletion(-)
>>>>
>>>> diff --git a/drivers/mtd/spi-nor/cadence-quadspi.c b/drivers/mtd/spi-nor/cadence-quadspi.c
>>>> index 53c7d8e0327a..5cd5d6f7303f 100644
>>>> --- a/drivers/mtd/spi-nor/cadence-quadspi.c
>>>> +++ b/drivers/mtd/spi-nor/cadence-quadspi.c
>>>> @@ -38,6 +38,9 @@
>>>>  #define CQSPI_NAME			"cadence-qspi"
>>>>  #define CQSPI_MAX_CHIPSELECT		16
>>>>  
>>>> +/* Quirks */
>>>> +#define CQSPI_NEEDS_WR_DELAY		BIT(0)
>>>> +
>>>>  struct cqspi_st;
>>>>  
>>>>  struct cqspi_flash_pdata {
>>>> @@ -76,6 +79,7 @@ struct cqspi_st {
>>>>  	u32			fifo_depth;
>>>>  	u32			fifo_width;
>>>>  	u32			trigger_address;
>>>> +	u32			wr_delay;
>>>>  	struct cqspi_flash_pdata f_pdata[CQSPI_MAX_CHIPSELECT];
>>>>  };
>>>>  
>>>> @@ -608,6 +612,15 @@ static int cqspi_indirect_write_execute(struct spi_nor *nor,
>>>>  	reinit_completion(&cqspi->transfer_complete);
>>>>  	writel(CQSPI_REG_INDIRECTWR_START_MASK,
>>>>  	       reg_base + CQSPI_REG_INDIRECTWR);
>>>> +	/*
>>>> +	 * As per 66AK2G02 TRM SPRUHY8F section 11.15.5.3 Indirect Access
>>>> +	 * Controller programming sequence, couple of cycles of
>>>> +	 * QSPI_REF_CLK delay is required for the above bit to
>>>> +	 * be internally synchronized by the QSPI module. Provide 5
>>>> +	 * cycles of delay.
>>>> +	 */
>>>> +	if (cqspi->wr_delay)
>>>> +		ndelay(cqspi->wr_delay);
>>>>  
>>>>  	while (remaining > 0) {
>>>>  		write_bytes = remaining > page_size ? page_size : remaining;
>>>> @@ -1156,6 +1169,7 @@ static int cqspi_probe(struct platform_device *pdev)
>>>>  	struct cqspi_st *cqspi;
>>>>  	struct resource *res;
>>>>  	struct resource *res_ahb;
>>>> +	unsigned long data;
>>>>  	int ret;
>>>>  	int irq;
>>>>  
>>>> @@ -1213,6 +1227,10 @@ static int cqspi_probe(struct platform_device *pdev)
>>>>  	}
>>>>  
>>>>  	cqspi->master_ref_clk_hz = clk_get_rate(cqspi->clk);
>>>> +	data  = (unsigned long)of_device_get_match_data(dev);
>>>> +	if (data & CQSPI_NEEDS_WR_DELAY)
>>>> +		cqspi->wr_delay = 5 * DIV_ROUND_UP(NSEC_PER_SEC,
>>>> +						   cqspi->master_ref_clk_hz);
>>>>  
>>>>  	ret = devm_request_irq(dev, irq, cqspi_irq_handler, 0,
>>>>  			       pdev->name, cqspi);
>>>> @@ -1284,7 +1302,14 @@ static const struct dev_pm_ops cqspi__dev_pm_ops = {
>>>>  #endif
>>>>  
>>>>  static const struct of_device_id cqspi_dt_ids[] = {
>>>> -	{.compatible = "cdns,qspi-nor",},
>>>> +	{
>>>> +		.compatible = "cdns,qspi-nor",
>>>> +		.data = (void *)0,
>>>> +	},
>>>> +	{
>>>> +		.compatible = "ti,k2g-qspi",
>>>> +		.data = (void *)CQSPI_NEEDS_WR_DELAY,
>>>> +	},
>>>>  	{ /* end of table */ }
>>>>  };
>>>>  
>>>>
>>>
>>>
> 
>