[PATCH] pinctrl: cherryview: fix issues caused by dynamic gpio irqs mapping

From: Grygorii Strashko
Date: Tue Oct 03 2017 - 13:01:02 EST


New GPIO IRQs are allocated and mapped dynamically by default when
GPIO IRQ infrastructure is used by cherryview-pinctrl driver.
This causes issues on some Intel platforms [1][2] with broken BIOS which
hardcodes Linux IRQ numbers in their ACPI tables.

On such platforms cherryview-pinctrl driver should allocate and map all
GPIO IRQs at probe time.
Side effect - "Cannot allocate irq_descs @ IRQ%d, assuming pre-allocated\n"
can be seen at boot log.

NOTE. It still may fail if boot sequence will changed and some interrupt
controller will be probed before cherryview-pinctrl which will shift Linux IRQ
numbering (expected with CONFIG_SPARCE_IRQ enabled).

[1] https://bugzilla.kernel.org/show_bug.cgi?id=194945
[2] https://lkml.org/lkml/2017/9/28/153
Cc: Andy Shevchenko <andy.shevchenko@xxxxxxxxx>
Cc: Chris Gorman <chrisjohgorman@xxxxxxxxx>
Cc: Mika Westerberg <mika.westerberg@xxxxxxxxxxxxxxx>
Cc: Heikki Krogerus <heikki.krogerus@xxxxxxxxxxxxxxx>
Signed-off-by: Grygorii Strashko <grygorii.strashko@xxxxxx>
Reported-by: Chris Gorman <chrisjohgorman@xxxxxxxxx>
Reported-by: Mika Westerberg <mika.westerberg@xxxxxxxxxxxxxxx>
---
drivers/pinctrl/intel/pinctrl-cherryview.c | 14 +++++++++++++-
1 file changed, 13 insertions(+), 1 deletion(-)

diff --git a/drivers/pinctrl/intel/pinctrl-cherryview.c b/drivers/pinctrl/intel/pinctrl-cherryview.c
index 04e929f..fadbca9 100644
--- a/drivers/pinctrl/intel/pinctrl-cherryview.c
+++ b/drivers/pinctrl/intel/pinctrl-cherryview.c
@@ -1577,6 +1577,7 @@ static int chv_gpio_probe(struct chv_pinctrl *pctrl, int irq)
struct gpio_chip *chip = &pctrl->chip;
bool need_valid_mask = !dmi_check_system(chv_no_valid_mask);
int ret, i, offset;
+ int irq_base;

*chip = chv_gpio_chip;

@@ -1622,7 +1623,18 @@ static int chv_gpio_probe(struct chv_pinctrl *pctrl, int irq)
/* Clear all interrupts */
chv_writel(0xffff, pctrl->regs + CHV_INTSTAT);

- ret = gpiochip_irqchip_add(chip, &chv_gpio_irqchip, 0,
+ if (!need_valid_mask) {
+ irq_base = devm_irq_alloc_descs(pctrl->dev, -1, 0,
+ chip->ngpio, NUMA_NO_NODE);
+ if (irq_base < 0) {
+ dev_err(pctrl->dev, "Failed to allocate IRQ numbers\n");
+ return irq_base;
+ }
+ } else {
+ irq_base = 0;
+ }
+
+ ret = gpiochip_irqchip_add(chip, &chv_gpio_irqchip, irq_base,
handle_bad_irq, IRQ_TYPE_NONE);
if (ret) {
dev_err(pctrl->dev, "failed to add IRQ chip\n");
--
2.10.1