[PATCH V5 0/2] mmc: sdhci-msm: Configuring IO_PAD support for sdhci-msm
From: Vijay Viswanath
Date: Fri Apr 20 2018 - 08:15:53 EST
>From the HPG:
In some platform, SDCC controller can be connected to either an eMMC device or
an SD card. The PADs for SD card are dual-voltage that support 3v/1.8v. Those
PADs have a control signal (io_pad_pwr_switch/mode18 ) that indicates whether
the PAD works in 3v or 1.8v.
For SD usage the default value of this signal is ‘0’, and SD driver changes it
to ‘1’ as a part of voltage switching sequence.
For eMMC usage, SW should configure this signal to ‘1’ and supply 1.8v to PADs
before starting any activity on the eMMC BUS.
To set this signal, write the following in the
HC_IO_PAD_PWR_SWITCH: bit 16
HC_IO_PAD_PWR_SWITCH_EN: bit 15
Changes since v1:
Modified comments on io_pad related changes.
Split some read+modify+write commands to multiple lines
Changes since v2:
IO_PAD_PWR_SWITCH_EN will be set only if we have info regarding what
voltage is supported by the regulators.
Replaced regulator_list_voltage() API with
Changes since v3:
Removed unnecessary prints and extra lines.
Changes since v4:
Removed unnecessary mb() within sdhci_msm_handle_pwr_irq() since
wakeup calls have implicit write barriers.
Krishna Konda (1):
mmc: sdhci-msm: support voltage pad switching
Vijay Viswanath (1):
mmc: sdhci-msm: Add support to store supported vdd-io voltages
drivers/mmc/host/sdhci-msm.c | 99 +++++++++++++++++++++++++++++++++++++++++++-
1 file changed, 97 insertions(+), 2 deletions(-)
Qualcomm India Private Limited, on behalf of Qualcomm Innovation Center, Inc.
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, a Linux Foundation Collaborative Project.