Re: [PATCH 1/2] dt-bindings: spi: Add Spreadtrum SPI controller documentation

[Baolin Wang]

Hi Rob,

On 15 August 2018 at 04:21, Rob Herring <robh@xxxxxxxxxx> wrote:
> On Tue, Aug 07, 2018 at 06:43:37PM +0800, Baolin Wang wrote:
>> From: Lanqing Liu <lanqing.liu@xxxxxxxxxxxxxx>
>>
>> This patch adds the binding documentation for Spreadtrum SPI
>> controller device.
>>
>> Signed-off-by: Lanqing Liu <lanqing.liu@xxxxxxxxxxxxxx>
>> Signed-off-by: Baolin Wang <baolin.wang@xxxxxxxxxx>
>> ---
>>  Documentation/devicetree/bindings/spi/spi-sprd.txt |   31 ++++++++++++++++++++
>>  1 file changed, 31 insertions(+)
>>  create mode 100644 Documentation/devicetree/bindings/spi/spi-sprd.txt
>>
>> diff --git a/Documentation/devicetree/bindings/spi/spi-sprd.txt b/Documentation/devicetree/bindings/spi/spi-sprd.txt
>> new file mode 100644
>> index 0000000..06ff746
>> --- /dev/null
>> +++ b/Documentation/devicetree/bindings/spi/spi-sprd.txt
>> @@ -0,0 +1,31 @@
>> +Spreadtrum SPI Controller
>> +
>> +Required properties:
>> +- compatible: Should be "sprd,sc9860-spi".
>> +- reg: Offset and length of SPI controller register space.
>> +- interrupts: Should contain SPI interrupt.
>> +- clock-names: Should contain following entries:
>> +     "spi" for SPI clock,
>> +     "source" for SPI source (parent) clock,
>
> Do the h/w block actually get this clock or the driver needs it? In the
> latter case, it should not be in DT.

Yes, we will get the actual SPI source clock form the "source" clock property.

>
>> +     "enable" for SPI module enable clock.
>> +- clocks: List of clock input name strings sorted in the same order
>> +     as the clock-names property.
>> +- #address-cells: The number of cells required to define a chip select
>> +     address on the SPI bus. Should be set to 1.
>> +- #size-cells: Should be set to 0.
>> +
>> +Optional properties:
>> +- sprd,spi-interval: Specify the intervals of two SPI frames, which can be
>> +     converted to the delay clock cycles = interval number * 4 + 10.
>
> There are read and write delay properties you can use.

Right. We've agreed introducing another field for spi_transfer to
represent this and will remove 'sprd,spi-interval' from DT.

-- 
Baolin Wang
Best Regards