[PATCH V5 1/3] dt-bindings: soc: qcom: Remove SPI controller maximum frequency binding

[Alok Chauhan]

From: Dilip Kota <dkota@xxxxxxxxxxxxxx>

SPI controller driver should maintain the maximum frequency
of the controller instead of relying on device tree bindings.
Because maximum frequency is specific property of SPI
controller.

Signed-off-by: Dilip Kota <dkota@xxxxxxxxxxxxxx>
Reviewed-by: Douglas Anderson <dianders@xxxxxxxxxxxx>
Reviewed-by: Stephen Boyd <swboyd@xxxxxxxxxxxx>
Reviewed-by: Rob Herring <robh@xxxxxxxxxx>
Signed-off-by: Alok Chauhan <alokc@xxxxxxxxxxxxxx>
---
 Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt | 2 --
 1 file changed, 2 deletions(-)

diff --git a/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt b/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt
index ff92e5a..b9d0c21 100644
--- a/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt
+++ b/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt
@@ -60,7 +60,6 @@ Required properties:
 - interrupts:		Must contain SPI controller interrupts.
 - clock-names:		Must contain "se".
 - clocks:		Serial engine core clock needed by the device.
-- spi-max-frequency:	Specifies maximum SPI clock frequency, units - Hz.
 - #address-cells:	Must be <1> to define a chip select address on
 			the SPI bus.
 - #size-cells:		Must be <0>.
@@ -112,7 +111,6 @@ Example:
 			pinctrl-names = "default", "sleep";
 			pinctrl-0 = <&qup_1_spi_2_active>;
 			pinctrl-1 = <&qup_1_spi_2_sleep>;
-			spi-max-frequency = <19200000>;
 			#address-cells = <1>;
 			#size-cells = <0>;
 		};
-- 
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project