Re: [PATCH v2 bus+gpio 2/4] dt-bindings: bus: Document moxtet bus binding

[Rob Herring]

On Fri, Nov 02, 2018 at 11:35:37AM +0100, Marek Behún wrote:
> This adds device tree binding documentation for the Moxtet bus, a bus
> via which the different modules connected to the Turris Mox router can
> be configured.
> 
> Signed-off-by: Marek Behún <marek.behun@xxxxxx>
> Cc: Rob Herring <robh+dt@xxxxxxxxxx>
> Cc: devicetree@xxxxxxxxxxxxxxx
> ---
>  .../devicetree/bindings/bus/moxtet.txt        | 34 +++++++++++++++++++
>  1 file changed, 34 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/bus/moxtet.txt
> 
> diff --git a/Documentation/devicetree/bindings/bus/moxtet.txt b/Documentation/devicetree/bindings/bus/moxtet.txt
> new file mode 100644
> index 000000000000..19a1bab61e8a
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/bus/moxtet.txt
> @@ -0,0 +1,34 @@
> +Turris Mox module configuration bus (over SPI)
> +
> +Required properties:
> + - compatible		: Should be "cznic,moxtet".
> + - #address-cells	: Has to be 1
> + - #size-cells		: Has to be 0
> +For other required and optional properties of SPI slave nodes please refer to
> +../spi/spi-bus.txt.

You need to list what's required. spi-cpol and spi-cpha are typically 
required or not.

> +
> +Required properties of subnodes:
> + - reg			: Should be position on the Moxtet bus
> +
> +The driver finds the devices connected to the bus by itself, but it may be
> +needed to reference some of them from other parts of the device tree. In that
> +case the devices can be defined as subnodes of the moxtet node.
> +
> +Example:
> +
> +	moxtet@1 {
> +		#address-cells = <1>;
> +		#size-cells = <0>;
> +		compatible = "cznic,moxtet";
> +		reg = <1>;
> +		spi-max-frequency = <10000000>;
> +		spi-cpol;
> +		spi-cpha;
> +
> +		moxtet_sfp: moxtet-sfp@0 {

gpio@0

> +			compatible = "cznic,moxtet-sfp";
> +			gpio-controller;
> +			#gpio-cells = <2>;
> +			reg = <0>;
> +		}
> +	};
> -- 
> 2.18.1
>