Re: [PATCH v1 3/4] Bluetooth: hci_qca: clear HCI_QUIRK_RESET_ON_CLOSE flag

[Marcel Holtmann]

Hi Balakrishna,

> During hci down we are sending reset command to chip, which
> is not required for wcn3990, as hdev->shutdown() will turn off the
> regulators.
> 
> Signed-off-by: Balakrishna Godavarthi <bgodavar@xxxxxxxxxxxxxx>
> ---
> drivers/bluetooth/hci_qca.c | 1 +
> 1 file changed, 1 insertion(+)
> 
> diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c
> index 8301663f0004..97b57e0f4725 100644
> --- a/drivers/bluetooth/hci_qca.c
> +++ b/drivers/bluetooth/hci_qca.c
> @@ -1190,6 +1190,7 @@ static int qca_setup(struct hci_uart *hu)
> 		 */
> 		set_bit(HCI_QUIRK_NON_PERSISTENT_SETUP, &hdev->quirks);
> 		set_bit(HCI_QUIRK_USE_BDADDR_PROPERTY, &hdev->quirks);
> +		clear_bit(HCI_QUIRK_RESET_ON_CLOSE, &hdev->quirks);
> 		hu->hdev->shutdown = qca_power_off;
> 		ret = qca_wcn3990_init(hu);
> 		if (ret)

I am pretty certain that you didnât want this quirk:

        /* When this quirk is set, the HCI Reset command is send when            
         * closing the transport instead of when opening it.

This quirk is for Bluetooth 1.0b devices where the HCI_Reset behavior was not clear or for devices that actually misbehave with the initial HCI_Reset.

In addition, you commit message is totally misleading. That is not what is happening with this quirk.

Regards

Marcel