Re: [PATCH 1/2] pwm: kconfig: enable kona pwm to be built for cygnus arch

[Scott Branden]

On 2018-11-07 8:12 a.m., Uwe Kleine-KÃnig wrote:
> On Wed, Nov 07, 2018 at 10:36:12AM +0100, ClÃment PÃron wrote:
> > The Cygnus architecture use a Kona PWM. This is already present
> > in the device tree but can't be built actually. Hence, allow the
> > Kona PWM to be built for Cygnus arch.
> >
> > Signed-off-by: ClÃment PÃron <peron.clem@xxxxxxxxx>
> > ---
> >   drivers/pwm/Kconfig | 3 ++-
> >   1 file changed, 2 insertions(+), 1 deletion(-)
> >
> > diff --git a/drivers/pwm/Kconfig b/drivers/pwm/Kconfig
> > index 763ee50ea57d..76d56fc8b1b7 100644
> > --- a/drivers/pwm/Kconfig
> > +++ b/drivers/pwm/Kconfig
> > @@ -88,7 +88,8 @@ config PWM_BCM_IPROC
> >   
> >   config PWM_BCM_KONA
> >   	tristate "Kona PWM support"
> > -	depends on ARCH_BCM_MOBILE
> > +	depends on ARCH_BCM_MOBILE || ARCH_BCM_CYGNUS
> > +	default ARCH_BCM_CYGNUS
> Is it possible to build this driver also on other arches? Then you might
> want to consider
>
> 	depends on ARCH_BCM_MOBILE || ARCH_BCM_CYGNUS || COMPILE_TEST
good idea to add the COMPILE_TEST just to increase compile coverage
> Best regards
> Uwe