Re: [PATCH 6/7] net: phy: icplus: implement .did_interrupt for IP101A/G

[Andrew Lunn]

On Sat, Nov 17, 2018 at 07:20:06PM +0100, Martin Blumenstingl wrote:
> The IP101A_G_IRQ_CONF_STATUS register has bits to detect which
> interrupts have fired. Implement the .did_interrupt callback to let the
> PHY core know whether the interrupt was for this specific PHY.
> 
> This is useful for debugging interrupt problems with 32-pin IP101GR PHYs
> where the interrupt line is shared with the RX_ERR (receive error
> status) signal. The default values are:
> - RX_ERR is enabled by default (LOW means that there is no receive
>   error)
> - the PHY's interrupt line is configured "active low" by default
> 
> Without any additional changes there is a flood of interrupts if the
> RX_ERR/INTR32 signal is configured in RX_ERR mode (which is the
> default). Having a did_interrupt ensures that the PHY core returns
> IRQ_NONE instead of endlessly triggering the PHY state machine.
> Additionally the kernel will report this after a while:
>   irq 28: nobody cared (try booting with the "irqpoll" option)

That is a useful hint.

> 
> Signed-off-by: Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx>

Reviewed-by: Andrew Lunn <andrew@xxxxxxx>

    Andrew