Re: [PATCH v2 1/7] dt-bindings: power: supply: bq24190_charger: add bq24192 and usb-otg-vbus

[Sebastian Reichel]

Hi,

On Wed, Oct 31, 2018 at 08:11:43PM -0400, Brian Masney wrote:
> Add support for the ti,bq24192 variant and a child node for the
> usb-otg-vbus regulator.
> 
> Signed-off-by: Brian Masney <masneyb@xxxxxxxxxxxxx>
> ---

Thanks, queued.

-- Sebastian

>  .../devicetree/bindings/power/supply/bq24190.txt         | 9 +++++++++
>  1 file changed, 9 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/power/supply/bq24190.txt b/Documentation/devicetree/bindings/power/supply/bq24190.txt
> index 9e517d307070..c8ac028bd3c7 100644
> --- a/Documentation/devicetree/bindings/power/supply/bq24190.txt
> +++ b/Documentation/devicetree/bindings/power/supply/bq24190.txt
> @@ -3,6 +3,7 @@ TI BQ24190 Li-Ion Battery Charger
>  Required properties:
>  - compatible: contains one of the following:
>      * "ti,bq24190"
> +    * "ti,bq24192"
>      * "ti,bq24192i"
>  - reg: integer, I2C address of the charger.
>  - interrupts[-extended]: configuration for charger INT pin.
> @@ -19,6 +20,12 @@ Optional properties:
>  - ti,system-minimum-microvolt: when power is connected and the battery is below
>    minimum system voltage, the system will be regulated above this setting.
>  
> +child nodes:
> +- usb-otg-vbus:
> +  Usage: optional
> +  Description: Regulator that is used to control the VBUS voltage direction for
> +               either USB host mode or for charging on the OTG port.
> +
>  Notes:
>  - Some circuit boards wire the chip's "OTG" pin high (enabling 500mA default
>    charge current on USB SDP ports, among other features). To simulate this on
> @@ -39,6 +46,8 @@ Example:
>  		interrupts-extended = <&gpiochip 10 IRQ_TYPE_EDGE_FALLING>;
>  		monitored-battery = <&bat>;
>  		ti,system-minimum-microvolt = <3200000>;
> +
> +		usb_otg_vbus: usb-otg-vbus { };
>  	};
>  
>  	&twl_gpio {
> -- 
> 2.17.2
>

Attachment: signature.asc
Description: PGP signature