RE: [PATCH 0/3] can: flexcan: add imx8qm support

[Joakim Zhang]

Kindly Ping...

Best Regards,
Joakim Zhang

> -----Original Message-----
> From: Joakim Zhang
> Sent: 2018年12月19日 16:39
> To: mkl@xxxxxxxxxxxxxx; linux-can@xxxxxxxxxxxxxxx
> Cc: wg@xxxxxxxxxxxxxx; netdev@xxxxxxxxxxxxxxx;
> linux-kernel@xxxxxxxxxxxxxxx; dl-linux-imx <linux-imx@xxxxxxx>; Joakim
> Zhang <qiangqing.zhang@xxxxxxx>
> Subject: [PATCH 0/3] can: flexcan: add imx8qm support
> 
> This patch set intends to add Flexcan support for i.MX8QM platform which
> defaultly supports CAN FD protocol. Although BRS enabled by system reset
> when the driver sets CAN FD mode, now this patch serial does not support BRS
> in the driver. And then I will send patch to enable BRS by changing the register
> to set bit timing.
> 
> Dong Aisheng (3):
>   can: rx-offload: add CANFD support based on offload
>   can: flexcan: add CAN FD mode support
>   can: flexcan: add imx8qm support
> 
>  drivers/net/can/flexcan.c      | 114 ++++++++++++++++++++++++++++++---
>  drivers/net/can/rx-offload.c   |  16 +++--
>  include/linux/can/rx-offload.h |   4 +-
>  3 files changed, 117 insertions(+), 17 deletions(-)
> 
> --
> 2.17.1