Re: [PATCH 0/8] drm/meson: Add support for HDMI2.0 4k60

[Neil Armstrong]

Le 01/02/2019 11:25, Andrzej Hajda a Ãcrit :
> On 31.01.2019 16:50, Neil Armstrong wrote:
>> On 31/01/2019 15:13, Andrzej Hajda wrote:
>>> On 31.01.2019 14:25, Neil Armstrong wrote:
>>>> Hi Andrzej, Laurent,
>>>>
>>>> On 15/01/2019 13:33, Neil Armstrong wrote:
>>>>> This patchset aims to add support for the following HDMI2.0 4k60 modes:
>>>>> - 594Mhz TMDS frequency needing TMDS Scramling and 1/40 rate for RGB/YUV4:4:4
>>>>> - 297MHz TMDS frequency with YUV4:2:0 encoding
>>>>>
>>>>> The first mode uses the SCDC helpers introduced by intel to :
>>>>> - discover where the monitor support SCDC
>>>>> - setup the SCDC parameters
>>>>> This is implemented in the dw-hdmi bridge driver by handling scrambling
>>>>> support during the bridge setup and by exporting an helper for the PHY
>>>>> setup to setup the SCDC configuration for the 1/40 TMDS rate.
>>>>> This code will only be active if the encoder support a TMDS rate > 340MHz.
>>>>>
>>>>> This patch could eventually break support on different SoC when connected
>>>>> on a 4k60 monitor with SCDC :
>>>>> - i.MX correctly discards pixel clocks > 216MHz
>>>>> - R-CAR discards discards pixel clocks > 297MHz since [1]
>>>>> - Rockchip discards invalid pixel clocks not in the rockchip_mpll_cfg table
>>>>> - sun8i correctly discards pixel clocks > 297MHz on a83t
>>>>> - sun8i discards discards pixel clocks > 594Mhz on h6, which is already broken
>>>>>
>>>>> First patch should fix support for Allwinner H6.
>>>>>
>>>>> The second mode is implemented by added the missing 4:2:0 bypass handling
>>>>> in the dw-hdmi bridge driver and adding a "mtmdsclock" separating the
>>>>> pixel clock from the tmds clock in the mode setup phase.
>>>>> We also enable support for these modes in the connector only if the platform
>>>>> glue code explicits the support.
>>>> Do you think patches 1-4 could be applied ?
>>>
>>> For me they are OK.
>>>
>>> Should I take them via drm-misc?
>> OK for me !
>>
>> Neil
> 
> 
> These patches do not apply. Could you rebase them on drm-misc-next.

Sure, re-spinning.

Neil

> 
> 
> Regards
> 
> Andrzej
> 
> 
> 
>>
>>>
>>>> Then we could focus on how we manage the bus format between the encoder
>>>> and the bridge ?
>>>>
>>>> Especially patch 5 linked to patch 7.
>>>>
>>>> Will one of you be at FOSDEM 2019 ? we could chat about this.
>>>
>>> Nope.
>>>
>>>
>>> Regards
>>>
>>> Andrzej
>>>
>>>
>>>> Following subjects on the table will be :
>>>> - HDR metadata transmission aligned with the last patchset sent by intel-gfx
>>>> - Colorspace connector property aligned with the last patchset sent by intel-gfx
>>>> - HDCP 1.4 and 2.2 handling
>>>>
>>>> Neil
>>>>
>>>>> Only the meson DRM dw_hdmi glue allows ycbcr420 modes, so no breakage
>>>>> is expected here.
>>>>>
>>>>> The remaining patches adds support for :
>>>>> - 1/40 TMDS rate aka DIV40 in the dw-hdmi meson PHY setup
>>>>> - 4:2:0 output and clock setup
>>>>>
>>>>> The dw-hdmi support re-uses the support done by Rockchip engineers on the
>>>>> Linux 4.4 BSP kernel.
>>>>>
>>>>> These modes has been validated using a MuxLab HDMI Signal Analyser in
>>>>> addition to different UHD TVs supporting full 4k60 or the 4:2:0 variant.
>>>>>
>>>>> Changes since RFC v2 at [3]:
>>>>> - Collected tested-by and reviewed-by tags
>>>>> - Changed if condition in "add HDMI div40 TMDS mode"
>>>>> - Updated "Add YUV420 output support" with the same if condition
>>>>>
>>>>> Changes since RFC v1 at [2]:
>>>>> - Fix all comments from Laurent :
>>>>> - Add define for HDMI 1.4 max tmds clock and SCDC supported version
>>>>> - Call dw_hdmi_set_high_tmds_clock_ratio() in dw_hdmi_phy_enable_powerdown()
>>>>> to unbreak Allwinner H6
>>>>> - Pass in_t(u8, bytes, SCDC_MIN_SOURCE_VERSION) as SCDC version
>>>>> - Finally add comments for SCDC and Scrambling process
>>>>>
>>>>> [1] https://patchwork.freedesktop.org/patch/263616/
>>>>> [2] https://patchwork.freedesktop.org/series/52950/#rev1
>>>>> [3] https://patchwork.freedesktop.org/series/52950/#rev2
>>>>>
>>>>> Neil Armstrong (7):
>>>>>   drm/bridge: dw-hdmi: Add SCDC and TMDS Scrambling support
>>>>>   drm/meson: add HDMI div40 TMDS mode
>>>>>   drm/meson: add support for HDMI2.0 2160p modes
>>>>>   drm/bridge: dw-hdmi: add support for YUV420 output
>>>>>   drm/bridge: dw-hdmi: allow ycbcr420 modes for >= 0x200a
>>>>>   drm/meson: Add YUV420 output support
>>>>>   drm/meson: Output in YUV444 if sink supports it
>>>>>
>>>>> Zheng Yang (1):
>>>>>   drm/bridge: dw-hdmi: support dynamically get input/out color info
>>>>>
>>>>>  drivers/gpu/drm/bridge/synopsys/dw-hdmi.c | 182 +++++++++++++++++++---
>>>>>  drivers/gpu/drm/bridge/synopsys/dw-hdmi.h |   1 +
>>>>>  drivers/gpu/drm/meson/meson_dw_hdmi.c     | 128 ++++++++++++---
>>>>>  drivers/gpu/drm/meson/meson_vclk.c        |  93 ++++++++---
>>>>>  drivers/gpu/drm/meson/meson_vclk.h        |   7 +-
>>>>>  drivers/gpu/drm/meson/meson_venc.c        |   8 +-
>>>>>  drivers/gpu/drm/meson/meson_venc.h        |  11 ++
>>>>>  drivers/gpu/drm/meson/meson_venc_cvbs.c   |   3 +-
>>>>>  include/drm/bridge/dw_hdmi.h              |   7 +
>>>>>  9 files changed, 374 insertions(+), 66 deletions(-)
>>>>>
>>>>
>>> _______________________________________________
>>> dri-devel mailing list
>>> dri-devel@xxxxxxxxxxxxxxxxxxxxx
>>> https://lists.freedesktop.org/mailman/listinfo/dri-devel
>>>
>>
>>
>