Re: [PATCH] Input: cap11xx - switch to using set_brightness_blocking()

[Jacek Anaszewski]

Hi Dmitry,

On 2/5/19 11:20 PM, Dmitry Torokhov wrote:
> Updating LED state requires access to regmap and therefore we may sleep, so
> we could not do that directly form set_brightness() method. Historically
> we used private work to adjust the brightness, but with the introduction of
> set_brightness_blocking() we no longer need it.
>
> As a bonus, not having our own work item means we do not have
> use-after-free issue as we neglected to cancel outstanding work on driver
> unbind.
>
> Reported-by: Sven Van Asbroeck <thesven73@xxxxxxxxx>
> Signed-off-by: Dmitry Torokhov <dmitry.torokhov@xxxxxxxxx>
> ---
>   drivers/input/keyboard/cap11xx.c | 47 ++++++++++++++------------------
>   1 file changed, 21 insertions(+), 26 deletions(-)
>
> diff --git a/drivers/input/keyboard/cap11xx.c b/drivers/input/keyboard/cap11xx.c
> index 312916f99597..c0baf323ddda 100644
> --- a/drivers/input/keyboard/cap11xx.c
> +++ b/drivers/input/keyboard/cap11xx.c
> @@ -75,9 +75,8 @@
>   struct cap11xx_led {
>   	struct cap11xx_priv *priv;
>   	struct led_classdev cdev;
> -	struct work_struct work;
>   	u32 reg;
> -	enum led_brightness new_brightness;
> +	enum led_brightness brightness;
>   };
>   #endif
>   
> @@ -233,30 +232,28 @@ static void cap11xx_input_close(struct input_dev *idev)
>   }
>   
>   #ifdef CONFIG_LEDS_CLASS
> -static void cap11xx_led_work(struct work_struct *work)
> -{
> -	struct cap11xx_led *led = container_of(work, struct cap11xx_led, work);
> -	struct cap11xx_priv *priv = led->priv;
> -	int value = led->new_brightness;
> -
> -	/*
> -	 * All LEDs share the same duty cycle as this is a HW limitation.
> -	 * Brightness levels per LED are either 0 (OFF) and 1 (ON).
> -	 */
> -	regmap_update_bits(priv->regmap, CAP11XX_REG_LED_OUTPUT_CONTROL,
> -				BIT(led->reg), value ? BIT(led->reg) : 0);
> -}
> -
> -static void cap11xx_led_set(struct led_classdev *cdev,
> -			   enum led_brightness value)
> +static int cap11xx_led_set(struct led_classdev *cdev,
> +			    enum led_brightness value)
>   {
>   	struct cap11xx_led *led = container_of(cdev, struct cap11xx_led, cdev);
> +	struct cap11xx_priv *priv = led->priv;
> +	int error = 0;
> +
> +	if (led->brightness != value) {

I'd say this check is not needed. If registers are not marked volatile
then regmap should not do the actual write to the hardware if the value
is equal to the cached one.

> +		/*
> +		 * All LEDs share the same duty cycle as this is a HW
> +		 * limitation. Brightness levels per LED are either
> +		 * 0 (OFF) and 1 (ON).
> +		 */
> +		error = regmap_update_bits(priv->regmap,
> +					   CAP11XX_REG_LED_OUTPUT_CONTROL,
> +					   BIT(led->reg),
> +					   value ? BIT(led->reg) : 0);
> +		if (!error)
> +			led->brightness = value;
> +	}
>   
> -	if (led->new_brightness == value)
> -		return;
> -
> -	led->new_brightness = value;
> -	schedule_work(&led->work);
> +	return error;
>   }
>   
>   static int cap11xx_init_leds(struct device *dev,
> @@ -299,7 +296,7 @@ static int cap11xx_init_leds(struct device *dev,
>   		led->cdev.default_trigger =
>   			of_get_property(child, "linux,default-trigger", NULL);
>   		led->cdev.flags = 0;
> -		led->cdev.brightness_set = cap11xx_led_set;
> +		led->cdev.brightness_set_blocking = cap11xx_led_set;
>   		led->cdev.max_brightness = 1;
>   		led->cdev.brightness = LED_OFF;
>   
> @@ -312,8 +309,6 @@ static int cap11xx_init_leds(struct device *dev,
>   		led->reg = reg;
>   		led->priv = priv;
>   
> -		INIT_WORK(&led->work, cap11xx_led_work);
> -
>   		error = devm_led_classdev_register(dev, &led->cdev);
>   		if (error) {
>   			of_node_put(child);

--
Best regards,
Jacek Anaszewski