Re: [PATCH RFC 7/9] cpufreq: qcom: Add support to update cpu node's OPP tables

[Viresh Kumar]

On 10-04-19, 16:46, Sibi Sankar wrote:
> On 2019-04-10 16:03, Viresh Kumar wrote:
> > On 28-03-19, 20:58, Sibi Sankar wrote:
> > > Add support to parse and update OPP tables attached to the cpu nodes.
> > > 
> > > Signed-off-by: Sibi Sankar <sibis@xxxxxxxxxxxxxx>
> > > ---
> > >  drivers/cpufreq/qcom-cpufreq-hw.c | 29 +++++++++++++++++++++++++++--
> > >  1 file changed, 27 insertions(+), 2 deletions(-)
> > > 
> > > diff --git a/drivers/cpufreq/qcom-cpufreq-hw.c
> > > b/drivers/cpufreq/qcom-cpufreq-hw.c
> > > index 4b0b50403901..5c268dd2346c 100644
> > > --- a/drivers/cpufreq/qcom-cpufreq-hw.c
> > > +++ b/drivers/cpufreq/qcom-cpufreq-hw.c
> > > @@ -73,6 +73,25 @@ static unsigned int
> > > qcom_cpufreq_hw_fast_switch(struct cpufreq_policy *policy,
> > >  	return policy->freq_table[index].frequency;
> > >  }
> > > 
> > > +static int qcom_find_update_opp(struct device *cpu_dev, unsigned
> > > long freq,
> > > +				unsigned long volt)
> > > +{
> > > +	int ret;
> > > +	struct dev_pm_opp *opp;
> > > +
> > > +	opp = dev_pm_opp_find_freq_exact(cpu_dev, freq, true);
> > > +	if (IS_ERR(opp)) {
> > > +		ret = dev_pm_opp_add(cpu_dev, freq, volt);
> > 
> > With my comment on the other patch, you can just call
> > dev_pm_opp_update_voltage() and if that fails then call
> > dev_pm_opp_add().
> 
> yeah that should simplify things.
> 
> Also through the above approach I cannot
> really disable opps that the OSM does not
> support. I can only try enabling opp's that
> OSM supports. But that would require all
> opp's nodes to start with "disabled" but
> that is not allowed I guess.

Yeah maybe add all OPPs from DT, disable all of them and then only modify and
enable the ones you need.

-- 
viresh