[PATCH v3 02/11] net: stmmac: sun8i: force select external PHY when no internal one

From: megous
Date: Thu Apr 11 2019 - 06:21:38 EST

From: Icenowy Zheng <icenowy@xxxxxxx>

The PHY selection bit also exists on SoCs without an internal PHY; if it's
set to 1 (internal PHY, default value) then the MAC will not make use of
any PHY such SoCs.

This problem appears when adapting for H6, which has no real internal PHY
(the "internal PHY" on H6 is not on-die, but on a co-packaged AC200 chip,
connected via RMII interface at GPIO bank A).

Force the PHY selection bit to 0 when the SOC doesn't have an internal PHY,
to address the problem of a wrong default value.

Signed-off-by: Icenowy Zheng <icenowy@xxxxxxx>
Signed-off-by: Ondrej Jirman <megous@xxxxxxxxxx>
drivers/net/ethernet/stmicro/stmmac/dwmac-sun8i.c | 5 +++++
1 file changed, 5 insertions(+)

diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-sun8i.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-sun8i.c
index 20c19afb8316..cb7e7f53be7d 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac-sun8i.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-sun8i.c
@@ -907,6 +907,11 @@ static int sun8i_dwmac_set_syscon(struct stmmac_priv *priv)
* address. No need to mask it again.
reg |= 1 << H3_EPHY_ADDR_SHIFT;
+ } else {
+ /* For SoCs without internal PHY the PHY selection bit should be
+ * set to 0 (external PHY).
+ */
+ reg &= ~H3_EPHY_SELECT;

if (!of_property_read_u32(node, "allwinner,tx-delay-ps", &val)) {