Re: [RFC] Question about reset order for xhci controller and pci

[Tangnianyao (ICT)]

Using command "echo 1 > /sys/bus/pci/devices/0000:7a:02.0/reset"
on centos7.5 system to reset xhci.

On 2019/4/26 11:07, Tangnianyao (ICT) wrote:
> Hi,all
> 
> I've meet a problem about reset xhci and it may be caused by the
> reset order of pci and xhci.
> Using xhci-pci, when users send reset command in os(centos or red-hat os),
> it would first reset PCI device by pci_reset_function. During this
> process, it would disable BME(Bus Master Enable) and set BME=0, and
> then enable it and set BME=1.
> And then it comes to xhci reset process. First, it would send an
> endpoint stop command in xhci_urb_dequeue. However, this stop ep command
> fails to finish. The reason is that BME is set to 0 in former process and
> xhci RUN/STOP changes to 0, and when BME is set to 1 again, RUN/STOP doesn't
> recover to 1.
> I've checked BME behavior in xhci spec, it shows that "If the BME bit is set to 0
> when xHC is running, the xHC may treat this as a Host Controller Error, asserting
> HCE(1) and immediately halt(R/S=0 and HCH=1). Recovery from this state will
> require an HCRST." It seems that the stop ep command failure is reasonable.
> Maybe I've missed something and please let me know.
> 
> linux version:5.0.0-rc3
> 
> Thanks,
> Nianyao Tang
> 
> 
> .
>