Re: [PATCH v6 3/3] backlight: lm3630a: add firmware node support

[Brian Masney]

On Thu, May 02, 2019 at 11:19:50AM +0100, Daniel Thompson wrote:
> On 24/04/2019 10:25, Brian Masney wrote:
> > Add fwnode support to the lm3630a driver and optionally allow
> > configuring the label, default brightness level, and maximum brightness
> > level. The two outputs can be controlled by bank A and B independently
> > or bank A can control both outputs.
> > 
> > If the platform data was not configured, then the driver defaults to
> > enabling both banks. This patch changes the default value to disable
> > both banks before parsing the firmware node so that just a single bank
> > can be enabled if desired. There are no in-tree users of this driver.
> 
> In that case given I'd certainly entertain patches that move the config
> structures out of include/linux/platform_data and say the driver requires a
> proper entry in the hardware description! Not a requirement though.

OK, I'll submit patches for that after this series is merged.

Brian