[PATCH v11 0/2] usb: xhci: Add Clear_TT_Buffer

From: Jim Lin
Date: Mon Jun 03 2019 - 06:57:36 EST

USB 2.0 specification chapter 11.17.5 says "as part of endpoint halt
processing for full-/low-speed endpoints connected via a TT, the host
software must use the Clear_TT_Buffer request to the TT to ensure
that the buffer is not in the busy state".

In our case, a full-speed speaker (ConferenceCam) is behind a high-
speed hub (ConferenceCam Connect), sometimes once we get STALL on a
request we may continue to get STALL with the folllowing requests,
like Set_Interface.

Solution is to invoke usb_hub_clear_tt_buffer() to send
Clear_TT_Buffer request to the hub of the device for the following
Set_Interface requests to the device to get ACK successfully.

The Clear_TT_Buffer request sent to the hub includes the address of
the LS/FS child device in wValue field. usb_hub_clear_tt_buffer()
uses udev->devnum to set the address wValue. This won't work for
devices connected to xHC.

For other host controllers udev->devnum is the same as the address of
the usb device, chosen and set by usb core. With xHC the controller
hardware assigns the address, and won't be the same as devnum.

Here we have two patches.
One is to add devaddr in struct usb_device for
usb_hub_clear_tt_buffer() to use.
Another is to invoke usb_hub_clear_tt_buffer() for halt processing.

Signed-off-by: Jim Lin <jilin@xxxxxxxxxx>

Jim Lin (2):
usb: Add devaddr in struct usb_device
usb: xhci: Add Clear_TT_Buffer

drivers/usb/core/hub.c | 4 +++-
drivers/usb/host/xhci-ring.c | 27 ++++++++++++++++++++++++++-
drivers/usb/host/xhci.c | 23 +++++++++++++++++++++++
drivers/usb/host/xhci.h | 5 +++++
include/linux/usb.h | 2 ++
5 files changed, 59 insertions(+), 2 deletions(-)