Re: [PATCH] regulator: twl: mark vdd1/2 as continuous on twl4030

[Andreas Kemnade]

On Mon, 17 Jun 2019 12:40:48 +0100
Mark Brown <broonie@xxxxxxxxxx> wrote:

> On Mon, Jun 17, 2019 at 01:03:57PM +0200, Andreas Kemnade wrote:
> > Mark Brown <broonie@xxxxxxxxxx> wrote:  
> > > On Sat, Jun 15, 2019 at 06:33:14PM +0200, Andreas Kemnade wrote:  
> 
> > > Why is this a good fix and not defining the supported voltages?  These
> > > look like fairly standard linear range regulators.  
> 
> > I am fixing the definition of the two regulators in the patch.
> > I am defining them as continuous. 
> > Voltage ranges are defined in
> > arch/arm/boot/dts/twl4030.dtsi
> > Only the continuous flag is missing.  
> 
> > Is there anything else do you want to be defined?  
> 
> These regulators are not continuous regulators as far as I can see, they
> are normal linear range regulators and so should have their voltages
> enumerable like any other linear range regulator.

another thing which might be misleading: The patch belongs to the
section after
#define TWL4030_ADJUSTABLE_SMPS(label, offset, num, turnon_delay, remap_conf)

that might be easily misread (because of too less context in the diff),
or if line numbers change.
It is *not* for
#define TWL4030_ADJUSTABLE_LDO(label, offset, num, turnon_delay, remap_conf)

Regards,
Andreas