Re: [PATCH 11/16] net: phy: adin: PHY reset mechanisms

[Andrew Lunn]

On Mon, Aug 05, 2019 at 07:54:48PM +0300, Alexandru Ardelean wrote:
> The ADIN PHYs supports 4 types of reset:
> 1. The standard PHY reset via BMCR_RESET bit in MII_BMCR reg
> 2. Reset via GPIO
> 3. Reset via reg GeSftRst (0xff0c) & reload previous pin configs
> 4. Reset via reg GeSftRst (0xff0c) & request new pin configs
> 
> Resets 2 & 4 are almost identical, with the exception that the crystal
> oscillator is available during reset for 2.
> 
> Resetting via GeSftRst or via GPIO is useful when doing a warm reboot. If
> doing various settings via phytool or ethtool, the sub-system registers
> don't reset just via BMCR_RESET.
> 
> This change implements resetting the entire PHY subsystem during probe.
> During PHY HW init (phy_hw_init() logic) the PHY core regs will be reset
> again via BMCR_RESET. This will also need to happen during a PM resume.

phylib already has support for GPIO reset. So if possible, you should
not repeat that code here.

What is the difference between a GPIO reset, and a GPIO reset followed
by a subsystem soft reset?

   Andrew