Re: [Patch 01/19] dt-bindings: media: cal: update binding to use syscon

[Benoit Parrot]

Rob Herring <robh@xxxxxxxxxx> wrote on Tue [2019-Oct-29 08:20:09 -0500]:
> On Fri, Oct 18, 2019 at 10:34:19AM -0500, Benoit Parrot wrote:
> > Update Device Tree bindings for the CAL driver to use syscon to access
> > the phy config register instead of trying to map it directly.
> > 
> > Signed-off-by: Benoit Parrot <bparrot@xxxxxx>
> > ---
> >  Documentation/devicetree/bindings/media/ti-cal.txt | 14 +++++++++-----
> >  1 file changed, 9 insertions(+), 5 deletions(-)
> > 
> > diff --git a/Documentation/devicetree/bindings/media/ti-cal.txt b/Documentation/devicetree/bindings/media/ti-cal.txt
> > index ae9b52f37576..782f801b12a9 100644
> > --- a/Documentation/devicetree/bindings/media/ti-cal.txt
> > +++ b/Documentation/devicetree/bindings/media/ti-cal.txt
> > @@ -10,9 +10,14 @@ Required properties:
> >  - compatible: must be "ti,dra72-cal"
> >  - reg:	CAL Top level, Receiver Core #0, Receiver Core #1 and Camera RX
> >  	control address space
> > -- reg-names: cal_top, cal_rx_core0, cal_rx_core1, and camerrx_control
> > +- reg-names: cal_top, cal_rx_core0, cal_rx_core1 and camerrx_control
> >  	     registers
> >  - interrupts: should contain IRQ line for the CAL;
> > +- syscon-camerrx: phandle to the device control module and offset to the
> > +		  control_camerarx_core register
> > +		  This node is meant to replace the "camerrx_control" reg
> > +		  entry above but "camerrx_control" is still handled
> > +		  for backward compatibility.
> 
> Needs a vendor prefix and drop 'syscon'.

Hmm, I had chosen this syntax based on previous examples.
But I can change it. How about "ti,camerrx_control"?

> 
> >  
> >  CAL supports 2 camera port nodes on MIPI bus. Each CSI2 camera port nodes
> >  should contain a 'port' child node with child 'endpoint' node. Please
> > @@ -25,13 +30,12 @@ Example:
> >  		ti,hwmods = "cal";
> >  		reg = <0x4845B000 0x400>,
> >  		      <0x4845B800 0x40>,
> > -		      <0x4845B900 0x40>,
> > -		      <0x4A002e94 0x4>;
> > +		      <0x4845B900 0x40>;
> >  		reg-names = "cal_top",
> >  			    "cal_rx_core0",
> > -			    "cal_rx_core1",
> > -			    "camerrx_control";
> > +			    "cal_rx_core1";
> >  		interrupts = <GIC_SPI 119 IRQ_TYPE_LEVEL_HIGH>;
> > +		syscon-camerrx = <&scm_conf 0xE94>;
> >  		#address-cells = <1>;
> >  		#size-cells = <0>;
> >  
> > -- 
> > 2.17.1
> >