[PATCH 1/6] PCI/PM: Apply D2 delay as milliseconds, not microseconds

[Bjorn Helgaas]

From: Bjorn Helgaas <bhelgaas@xxxxxxxxxx>

PCI_PM_D2_DELAY is defined as 200, which is milliseconds, but previously we
used udelay(), which only waited for 200 microseconds.  Use msleep()
instead so we wait the correct amount of time.  See PCIe r5.0, sec 5.9.

Signed-off-by: Bjorn Helgaas <bhelgaas@xxxxxxxxxx>
---
 drivers/pci/pci.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/pci/pci.c b/drivers/pci/pci.c
index e7982af9a5d8..cd96874ae76d 100644
--- a/drivers/pci/pci.c
+++ b/drivers/pci/pci.c
@@ -886,7 +886,7 @@ static int pci_raw_set_power_state(struct pci_dev *dev, pci_power_t state)
 	if (state == PCI_D3hot || dev->current_state == PCI_D3hot)
 		pci_dev_d3_sleep(dev);
 	else if (state == PCI_D2 || dev->current_state == PCI_D2)
-		udelay(PCI_PM_D2_DELAY);
+		msleep(PCI_PM_D2_DELAY);
 
 	pci_read_config_word(dev, dev->pm_cap + PCI_PM_CTRL, &pmcsr);
 	dev->current_state = (pmcsr & PCI_PM_CTRL_STATE_MASK);
-- 
2.24.0.rc1.363.gb1bccd3e3d-goog