Re: [PATCH v4 00/13] phy: usb: Updates to Broadcom STB USB PHY driver

From: Kishon Vijay Abraham I
Date: Mon Jan 06 2020 - 00:23:50 EST




On 03/01/20 11:47 PM, Al Cooper wrote:
> This patchset contains various updates to the Broadcom STB USB Driver.
> The updates include:
> - Add support for 7216 and 7211 Broadcom SoCs which use the new
> Synopsys USB Controller.
> - Add support for USB Wake
> - Add various bug fixes.

merged, thanks!

-Kishon
>
>
> v4 - Fix mispelling, change Synopsis to Synopsys. Also add
> "Reviewed-by: Rob Herring" to bindings patch. There are no
> functional code changes in v4.
>
> v3 - Rebase to v5.5-rc1
>
> v2 - Changes based on review feedback
> - Add vendor prefix to DT property "syscon-piarbctl"
> - Use standard "wakeup" instead of "wake" for DT "interrupt-names"
>
> Al Cooper (13):
> phy: usb: EHCI DMA may lose a burst of DMA data for 7255xA0 family
> phy: usb: Get all drivers that use USB clks using correct
> enable/disable
> phy: usb: Put USB phys into IDDQ on suspend to save power in S2 mode
> phy: usb: Add "wake on" functionality
> phy: usb: Restructure in preparation for adding 7216 USB support
> dt-bindings: Add Broadcom STB USB PHY binding document
> phy: usb: Add support for new Synopsys USB controller on the 7216
> phy: usb: Add support for new Synopsys USB controller on the 7211b0
> phy: usb: fix driver to defer on clk_get defer
> phy: usb: PHY's MDIO registers not accessible without device installed
> phy: usb: bdc: Fix occasional failure with BDC on 7211
> phy: usb: USB driver is crashing during S3 resume on 7216
> phy: usb: Add support for wake and USB low power mode for 7211 S2/S5
>
> .../bindings/phy/brcm,brcmstb-usb-phy.txt | 69 ++-
> drivers/phy/broadcom/Makefile | 2 +-
> .../phy/broadcom/phy-brcm-usb-init-synopsys.c | 414 ++++++++++++++++++
> drivers/phy/broadcom/phy-brcm-usb-init.c | 226 +++++-----
> drivers/phy/broadcom/phy-brcm-usb-init.h | 148 ++++++-
> drivers/phy/broadcom/phy-brcm-usb.c | 269 ++++++++++--
> 6 files changed, 943 insertions(+), 185 deletions(-)
> create mode 100644 drivers/phy/broadcom/phy-brcm-usb-init-synopsys.c
>