RE: [PATCH 1/2] dt-bindings: arm: arm,scmi: add smc/hvc transports

From: Peng Fan
Date: Fri Feb 07 2020 - 03:10:08 EST


> Subject: Re: [PATCH 1/2] dt-bindings: arm: arm,scmi: add smc/hvc transports
>
> On Thu, Feb 06, 2020 at 09:01:25PM +0800, peng.fan@xxxxxxx wrote:
> > From: Peng Fan <peng.fan@xxxxxxx>
> >
> > SCMI could use SMC/HVC as tranports, so add into devicetree binding
> > doc.
> >
> > Signed-off-by: Peng Fan <peng.fan@xxxxxxx>
> > ---
> > Documentation/devicetree/bindings/arm/arm,scmi.txt | 4 +++-
> > 1 file changed, 3 insertions(+), 1 deletion(-)
> >
> > diff --git a/Documentation/devicetree/bindings/arm/arm,scmi.txt
> > b/Documentation/devicetree/bindings/arm/arm,scmi.txt
> > index f493d69e6194..03cff8b55a93 100644
> > --- a/Documentation/devicetree/bindings/arm/arm,scmi.txt
> > +++ b/Documentation/devicetree/bindings/arm/arm,scmi.txt
> > @@ -14,7 +14,7 @@ Required properties:
> >
> > The scmi node with the following properties shall be under the /firmware/
> node.
> >
> > -- compatible : shall be "arm,scmi"
> > +- compatible : shall be "arm,scmi" or "arm,scmi-smc"
> > - mboxes: List of phandle and mailbox channel specifiers. It should contain
> > exactly one or two mailboxes, one for transmitting messages("tx")
> > and another optional for receiving the notifications("rx") if @@
> > -25,6 +25,8 @@ The scmi node with the following properties shall be under
> the /firmware/ node.
> > protocol identifier for a given sub-node.
> > - #size-cells : should be '0' as 'reg' property doesn't have any size
> > associated with it.
> > +- arm,smc-id : SMC id required when using smc transports
> > +- arm,hvc-id : HVC id required when using hvc transports
>
> Don't the SMC ids get standardized?

For now, there is no standard SCMI SMC/HVC ID.

Sudeep, Is there any plan from ARM? Or how you think about this patch?

Thanks,
Peng.

>
> >
> > Optional properties:
> >
> > --
> > 2.16.4
> >