Re: [PATCH v2 0/2] Add support to get/set PHY attributes using PHY framework

[Vinod Koul]

On 09-07-20, 07:02, Swapnil Kashinath Jakhade wrote:
> Ping requesting review comments.
> https://lkml.org/lkml/2020/5/26/507

I dont have this, can you repost?

Thanks
> 
> Thanks & regards,
> Swapnil
> 
> > -----Original Message-----
> > From: Yuti Amonkar <yamonkar@xxxxxxxxxxx>
> > Sent: Tuesday, May 26, 2020 8:05 PM
> > To: linux-kernel@xxxxxxxxxxxxxxx; kishon@xxxxxx; robh+dt@xxxxxxxxxx;
> > mark.rutland@xxxxxxx; maxime@xxxxxxxxxx
> > Cc: nsekhar@xxxxxx; jsarha@xxxxxx; tomi.valkeinen@xxxxxx;
> > praneeth@xxxxxx; Milind Parab <mparab@xxxxxxxxxxx>; Swapnil Kashinath
> > Jakhade <sjakhade@xxxxxxxxxxx>; Yuti Suresh Amonkar
> > <yamonkar@xxxxxxxxxxx>
> > Subject: [PATCH v2 0/2] Add support to get/set PHY attributes using PHY
> > framework
> > 
> > This patch series adds support to use kernel PHY subsystem APIs to get/set
> > PHY attributes like number of lanes and maximum link rate.
> > 
> > It includes following patches:
> > 
> > 1. v2-0001-phy-Add-max_link_rate-as-a-PHY-attribute-and-APIs.patch
> > This patch adds max_link_rate as a PHY attribute along with a pair of APIs
> > that allow the generic PHY subsystem to get/set PHY attributes supported by
> > the PHY.
> > The PHY provider driver may use phy_set_attrs() API to set the values that
> > PHY supports.
> > The controller driver may then use phy_get_attrs() API to fetch the PHY
> > attributes in order to properly configure the controller.
> > 
> > 2. v2-0002-phy-phy-cadence-torrent-Use-kernel-PHY-API-to-set.patch
> > This patch uses kernel PHY API phy_set_attrs to set corresponding PHY
> > properties in Cadence Torrent PHY driver. This will enable drivers using this
> > PHY to read these properties using PHY framework.
> > 
> > The phy_get_attrs() API will be used in the DRM bridge driver [1] which is in
> > process of upstreaming.
> > 
> > [1]
> > 
> > https://lkml.org/lkml/2020/2/26/263
> > 
> > Version History:
> > 
> > v2:
> >     - Implemented single pair of functions to get/set all PHY attributes
> > 
> > Swapnil Jakhade (1):
> >   phy: phy-cadence-torrent: Use kernel PHY API to set PHY attributes
> > 
> > Yuti Amonkar (1):
> >   phy: Add max_link_rate as a PHY attribute and APIs to get/set
> >     phy_attrs
> > 
> >  drivers/phy/cadence/phy-cadence-torrent.c |  7 +++++++
> >  include/linux/phy/phy.h                   | 25 +++++++++++++++++++++++
> >  2 files changed, 32 insertions(+)
> > 
> > --
> > 2.17.1

-- 
~Vinod