Re: [PATCH v9 2/2] PCI: xilinx-cpm: Add Versal CPM Root Port driver

From: Bjorn Helgaas
Date: Thu Aug 06 2020 - 13:34:47 EST


On Thu, Aug 06, 2020 at 10:54:45AM +0100, Lorenzo Pieralisi wrote:
> On Wed, Aug 05, 2020 at 06:30:50PM -0500, Bjorn Helgaas wrote:
> > On Wed, Aug 05, 2020 at 05:03:26PM -0500, Bjorn Helgaas wrote:
> > > On Wed, Aug 05, 2020 at 10:39:28PM +0100, Lorenzo Pieralisi wrote:
> > > > On Wed, Aug 05, 2020 at 03:43:58PM -0500, Bjorn Helgaas wrote:
> > > > > On Tue, Jun 16, 2020 at 06:26:54PM +0530, Bharat Kumar Gogada wrote:
> > > > > > - Add support for Versal CPM as Root Port.
> > > > > > - The Versal ACAP devices include CCIX-PCIe Module (CPM). The integrated
> > > > > > block for CPM along with the integrated bridge can function
> > > > > > as PCIe Root Port.
> > > > > > - Bridge error and legacy interrupts in Versal CPM are handled using
> > > > > > Versal CPM specific interrupt line.
> > > > >
> > > > > > +static void xilinx_cpm_pcie_init_port(struct xilinx_cpm_pcie_port *port)
> > > > > > +{
> > > > > > + if (cpm_pcie_link_up(port))
> > > > > > + dev_info(port->dev, "PCIe Link is UP\n");
> > > > > > + else
> > > > > > + dev_info(port->dev, "PCIe Link is DOWN\n");
> > > > > > +
> > > > > > + /* Disable all interrupts */
> > > > > > + pcie_write(port, ~XILINX_CPM_PCIE_IDR_ALL_MASK,
> > > > > > + XILINX_CPM_PCIE_REG_IMR);
> > > > > > +
> > > > > > + /* Clear pending interrupts */
> > > > > > + pcie_write(port, pcie_read(port, XILINX_CPM_PCIE_REG_IDR) &
> > > > > > + XILINX_CPM_PCIE_IMR_ALL_MASK,
> > > > > > + XILINX_CPM_PCIE_REG_IDR);
> > > > > > +
> > > > > > + /*
> > > > > > + * XILINX_CPM_PCIE_MISC_IR_ENABLE register is mapped to
> > > > > > + * CPM SLCR block.
> > > > > > + */
> > > > > > + writel(XILINX_CPM_PCIE_MISC_IR_LOCAL,
> > > > > > + port->cpm_base + XILINX_CPM_PCIE_MISC_IR_ENABLE);
> > > > > > + /* Enable the Bridge enable bit */
> > > > > > + pcie_write(port, pcie_read(port, XILINX_CPM_PCIE_REG_RPSC) |
> > > > > > + XILINX_CPM_PCIE_REG_RPSC_BEN,
> > > > > > + XILINX_CPM_PCIE_REG_RPSC);
> > > > > > +}
> > > > > > +
> > > > > > +/**
> > > > > > + * xilinx_cpm_pcie_parse_dt - Parse Device tree
> > > > > > + * @port: PCIe port information
> > > > > > + * @bus_range: Bus resource
> > > > > > + *
> > > > > > + * Return: '0' on success and error value on failure
> > > > > > + */
> > > > > > +static int xilinx_cpm_pcie_parse_dt(struct xilinx_cpm_pcie_port *port,
> > > > > > + struct resource *bus_range)
> > > > > > +{
> > > > > > + struct device *dev = port->dev;
> > > > > > + struct platform_device *pdev = to_platform_device(dev);
> > > > > > + struct resource *res;
> > > > > > +
> > > > > > + port->cpm_base = devm_platform_ioremap_resource_byname(pdev,
> > > > > > + "cpm_slcr");
> > > > > > + if (IS_ERR(port->cpm_base))
> > > > > > + return PTR_ERR(port->cpm_base);
> > > > > > +
> > > > > > + res = platform_get_resource_byname(pdev, IORESOURCE_MEM, "cfg");
> > > > > > + if (!res)
> > > > > > + return -ENXIO;
> > > > > > +
> > > > > > + port->cfg = pci_ecam_create(dev, res, bus_range,
> > > > > > + &pci_generic_ecam_ops);
> > > > >
> > > > > Aren't we passing an uninitialized pointer (bus_range) here? This
> > > > > looks broken to me.
> > > > >
> > > > > The kernelci build warns about it:
> > > > > https://kernelci.org/build/next/branch/master/kernel/next-20200805/
> > > > >
> > > > > /scratch/linux/drivers/pci/controller/pcie-xilinx-cpm.c:557:39: warning: variable 'bus_range' is uninitialized when used here [-Wuninitialized]
> > > > >
> > > > > I'm dropping this for now. I can't believe this actually works.
> > > >
> > > > It is caused by my rebase to fix -next after the rework in pci/misc
> > > > (I had to drop the call to pci_parse_request_of_pci_ranges()).
> > > >
> > > > I will look into this tomorrow if Rob does not beat me to it.
> > > >
> > > > Apologies, it is a new driver that was based on an interface
> > > > that is being reworked, for good reasons, in pci/misc.
> > >
> > > Oh, yep, I think I see what happened. I'll try to fix this in hopes
> > > of making linux-next tonight.
> >
> > OK, I think I fixed it. Man, that was a lot of work for a git novice
> > like me ;) Current head: 6f119ec8d9c8 ("Merge branch 'pci/irq-error'")
>
> Sorry about that.

No problem, if I were less OCD and more smart about git, it would have
been trivial. But it did make it into the Aug 6 linux-next, so that's
good!