[PATCH v3 3/5] i2c: aspeed: Mask IRQ status to relevant bits

[Eddie James]

Mask the IRQ status to only the bits that the driver checks. This
prevents excessive driver warnings when operating in slave mode
when additional bits are set that the driver doesn't handle.

Signed-off-by: Eddie James <eajames@xxxxxxxxxxxxx>
Reviewed-by: Tao Ren <rentao.bupt@xxxxxxxxx>
---
 drivers/i2c/busses/i2c-aspeed.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/drivers/i2c/busses/i2c-aspeed.c b/drivers/i2c/busses/i2c-aspeed.c
index 31268074c422..724bf30600d6 100644
--- a/drivers/i2c/busses/i2c-aspeed.c
+++ b/drivers/i2c/busses/i2c-aspeed.c
@@ -69,6 +69,7 @@
  * These share bit definitions, so use the same values for the enable &
  * status bits.
  */
+#define ASPEED_I2CD_INTR_RECV_MASK			0xf000ffff
 #define ASPEED_I2CD_INTR_SDA_DL_TIMEOUT			BIT(14)
 #define ASPEED_I2CD_INTR_BUS_RECOVER_DONE		BIT(13)
 #define ASPEED_I2CD_INTR_SLAVE_MATCH			BIT(7)
@@ -604,6 +605,7 @@ static irqreturn_t aspeed_i2c_bus_irq(int irq, void *dev_id)
 	writel(irq_received & ~ASPEED_I2CD_INTR_RX_DONE,
 	       bus->base + ASPEED_I2C_INTR_STS_REG);
 	readl(bus->base + ASPEED_I2C_INTR_STS_REG);
+	irq_received &= ASPEED_I2CD_INTR_RECV_MASK;
 	irq_remaining = irq_received;
 
 #if IS_ENABLED(CONFIG_I2C_SLAVE)
-- 
2.26.2