[PATCH RFC net-next 17/19] net: mvpp2: set 802.3x GoP Flow Control mode

[stefanc]

From: Stefan Chulski <stefanc@xxxxxxxxxxx>

This patch fix GMAC TX flow control autoneg.
Flow control autoneg wrongly were disabled with enabled TX
flow control.

Signed-off-by: Stefan Chulski <stefanc@xxxxxxxxxxx>
---
 drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c b/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
index 757dfe0..06e1000 100644
--- a/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
+++ b/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
@@ -6321,7 +6321,7 @@ static void mvpp2_gmac_config(struct mvpp2_port *port, unsigned int mode,
 	old_ctrl4 = ctrl4 = readl(port->base + MVPP22_GMAC_CTRL_4_REG);
 
 	ctrl0 &= ~MVPP2_GMAC_PORT_TYPE_MASK;
-	ctrl2 &= ~(MVPP2_GMAC_INBAND_AN_MASK | MVPP2_GMAC_PCS_ENABLE_MASK);
+	ctrl2 &= ~(MVPP2_GMAC_INBAND_AN_MASK | MVPP2_GMAC_PCS_ENABLE_MASK | MVPP2_GMAC_FLOW_CTRL_MASK);
 
 	/* Configure port type */
 	if (phy_interface_mode_is_8023z(state->interface)) {
-- 
1.9.1