Re: [PATCH 0/2] TI K3 R5F remoteproc support on AM46x SoCs

[Suman Anna]

On 3/18/21 4:58 PM, Suman Anna wrote:
> Hi All,
> 
> The following series enhances the K3 R5F remoteproc driver to add support
> for the R5F clusters on the newer TI K3 AM64x SoC family. The AM64x SoCs
> have 2 R5FSS clusters and no DSPs. Both clusters are capable of supporting
> either the conventional Split-mode or a brand new "Single-CPU" mode.
> 
> The revised R5FSS IP has the following unique features:
>  1. The new Single-CPU mode allows the Core1 TCMs to be combined with
>     the Core0 TCMs effectively doubling the amount of TCMs available.
>     This is same behavior as LockStep-mode on J7200 SoCs, but all other
>     previous SoCs could only use the Core0 TCMs. This combined TCMs appear
>     contiguous at the respective Core0 TCM addresses.
>  2. TCMs are auto-initialized during module power-up, and the behavior
>     is programmable through a SEC_MMR register bit. This is same as on
>     J7200 SoCs, and is not present on earlier AM65x and J721E SoCs.
> 
> The series is based on 5.12-rc2, and can apply on top of the current
> rproc-next branch as well.

I had a small typo in the cover-letter subject line, should read "AM64x" instead
of "AM46x". Patches themselves use the correct term.

regards
Suman

> 
> regards
> Suman
> 
> Suman Anna (2):
>   dt-bindings: remoteproc: k3-r5f: Update bindings for AM64x SoCs
>   remoteproc: k3-r5: Extend support to R5F clusters on AM64x SoCs
> 
>  .../bindings/remoteproc/ti,k3-r5f-rproc.yaml  |  31 +++-
>  drivers/remoteproc/ti_k3_r5_remoteproc.c      | 155 ++++++++++++++----
>  2 files changed, 152 insertions(+), 34 deletions(-)
>