[PATCH 2/2] usb: dwc3: gadget: Ignore EP queue requests during bus reset

[Wesley Cheng]

The current dwc3_gadget_reset_interrupt() will stop any active
transfers, but only addresses blocking of EP queuing for while we are
coming from a disconnected scenario, i.e. after receiving the disconnect
event.  If the host decides to issue a bus reset on the device, the
connected parameter will still be set to true, allowing for EP queuing
to continue while we are disabling the functions.  To avoid this, set the
connected flag to false until the stop active transfers is complete.

Signed-off-by: Wesley Cheng <wcheng@xxxxxxxxxxxxxx>
---
 drivers/usb/dwc3/gadget.c | 9 +++++++++
 1 file changed, 9 insertions(+)

diff --git a/drivers/usb/dwc3/gadget.c b/drivers/usb/dwc3/gadget.c
index 6e14fdc..d5ed0f69 100644
--- a/drivers/usb/dwc3/gadget.c
+++ b/drivers/usb/dwc3/gadget.c
@@ -3327,6 +3327,15 @@ static void dwc3_gadget_reset_interrupt(struct dwc3 *dwc)
 	u32			reg;
 
 	/*
+	 * Ideally, dwc3_reset_gadget() would trigger the function
+	 * drivers to stop any active transfers through ep disable.
+	 * However, for functions which defer ep disable, such as mass
+	 * storage, we will need to rely on the call to stop active
+	 * transfers here, and avoid allowing of request queuing.
+	 */
+	dwc->connected = false;
+
+	/*
 	 * WORKAROUND: DWC3 revisions <1.88a have an issue which
 	 * would cause a missing Disconnect Event if there's a
 	 * pending Setup Packet in the FIFO.
-- 
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project