Re: [PATCH v11 1/9] drivers: thermal: tsens: Add VER_0 tsens version
From: Thara Gopinath
Date: Fri Mar 19 2021 - 09:12:23 EST
On 3/18/21 8:52 PM, Ansuel Smith wrote:
VER_0 is used to describe device based on tsens version before v0.1.
These device are devices based on msm8960 for example apq8064 or
ipq806x.
Hi Ansuel,
There are still checkpatch check warnings in this patch. Please run
checkpatch.pl --strict and fix them. Once that is done, you can add
Reviewed-by: Thara Gopinath <thara.gopinath@xxxxxxxxxx>
Warm Regards
Thara
Signed-off-by: Ansuel Smith <ansuelsmth@xxxxxxxxx>
---
drivers/thermal/qcom/tsens.c | 141 ++++++++++++++++++++++++++++-------
drivers/thermal/qcom/tsens.h | 4 +-
2 files changed, 116 insertions(+), 29 deletions(-)
diff --git a/drivers/thermal/qcom/tsens.c b/drivers/thermal/qcom/tsens.c
index d8ce3a687b80..277d9b17e949 100644
--- a/drivers/thermal/qcom/tsens.c
+++ b/drivers/thermal/qcom/tsens.c
@@ -12,6 +12,7 @@
#include <linux/of.h>
#include <linux/of_address.h>
#include <linux/of_platform.h>
+#include <linux/mfd/syscon.h>
#include <linux/platform_device.h>
#include <linux/pm.h>
#include <linux/regmap.h>
@@ -515,6 +516,15 @@ static irqreturn_t tsens_irq_thread(int irq, void *data)
dev_dbg(priv->dev, "[%u] %s: no violation: %d\n",
hw_id, __func__, temp);
}
+
+ if (tsens_version(priv) < VER_0_1) {
+ /* Constraint: There is only 1 interrupt control register for all
+ * 11 temperature sensor. So monitoring more than 1 sensor based
+ * on interrupts will yield inconsistent result. To overcome this
+ * issue we will monitor only sensor 0 which is the master sensor.
+ */
+ break;
+ }
}
return IRQ_HANDLED;
@@ -530,6 +540,13 @@ static int tsens_set_trips(void *_sensor, int low, int high)
int high_val, low_val, cl_high, cl_low;
u32 hw_id = s->hw_id;
+ if (tsens_version(priv) < VER_0_1) {
+ /* Pre v0.1 IP had a single register for each type of interrupt
+ * and thresholds
+ */
+ hw_id = 0;
+ }
+
dev_dbg(dev, "[%u] %s: proposed thresholds: (%d:%d)\n",
hw_id, __func__, low, high);
@@ -584,18 +601,21 @@ int get_temp_tsens_valid(const struct tsens_sensor *s, int *temp)
u32 valid;
int ret;
- ret = regmap_field_read(priv->rf[valid_idx], &valid);
- if (ret)
- return ret;
- while (!valid) {
- /* Valid bit is 0 for 6 AHB clock cycles.
- * At 19.2MHz, 1 AHB clock is ~60ns.
- * We should enter this loop very, very rarely.
- */
- ndelay(400);
+ /* VER_0 doesn't have VALID bit */
+ if (tsens_version(priv) >= VER_0_1) {
ret = regmap_field_read(priv->rf[valid_idx], &valid);
if (ret)
return ret;
+ while (!valid) {
+ /* Valid bit is 0 for 6 AHB clock cycles.
+ * At 19.2MHz, 1 AHB clock is ~60ns.
+ * We should enter this loop very, very rarely.
+ */
+ ndelay(400);
+ ret = regmap_field_read(priv->rf[valid_idx], &valid);
+ if (ret)
+ return ret;
+ }
}
/* Valid bit is set, OK to read the temperature */
@@ -608,15 +628,29 @@ int get_temp_common(const struct tsens_sensor *s, int *temp)
{
struct tsens_priv *priv = s->priv;
int hw_id = s->hw_id;
- int last_temp = 0, ret;
+ int last_temp = 0, ret, trdy;
+ unsigned long timeout;
- ret = regmap_field_read(priv->rf[LAST_TEMP_0 + hw_id], &last_temp);
- if (ret)
- return ret;
+ timeout = jiffies + usecs_to_jiffies(TIMEOUT_US);
+ do {
+ if (tsens_version(priv) == VER_0) {
+ ret = regmap_field_read(priv->rf[TRDY], &trdy);
+ if (ret)
+ return ret;
+ if (!trdy)
+ continue;
+ }
- *temp = code_to_degc(last_temp, s) * 1000;
+ ret = regmap_field_read(priv->rf[LAST_TEMP_0 + hw_id], &last_temp);
+ if (ret)
+ return ret;
- return 0;
+ *temp = code_to_degc(last_temp, s) * 1000;
+
+ return 0;
+ } while (time_before(jiffies, timeout));
+
+ return -ETIMEDOUT;
}
#ifdef CONFIG_DEBUG_FS
@@ -738,19 +772,31 @@ int __init init_common(struct tsens_priv *priv)
priv->tm_offset = 0x1000;
}
- res = platform_get_resource(op, IORESOURCE_MEM, 0);
- tm_base = devm_ioremap_resource(dev, res);
- if (IS_ERR(tm_base)) {
- ret = PTR_ERR(tm_base);
- goto err_put_device;
+ if (tsens_version(priv) >= VER_0_1) {
+ res = platform_get_resource(op, IORESOURCE_MEM, 0);
+ tm_base = devm_ioremap_resource(dev, res);
+ if (IS_ERR(tm_base)) {
+ ret = PTR_ERR(tm_base);
+ goto err_put_device;
+ }
+
+ priv->tm_map = devm_regmap_init_mmio(dev, tm_base, &tsens_config);
+ } else { /* VER_0 share the same gcc regs using a syscon */
+ struct device *parent = priv->dev->parent;
+
+ if (parent)
+ priv->tm_map = syscon_node_to_regmap(parent->of_node);
}
- priv->tm_map = devm_regmap_init_mmio(dev, tm_base, &tsens_config);
- if (IS_ERR(priv->tm_map)) {
+ if (IS_ERR_OR_NULL(priv->tm_map)) {
ret = PTR_ERR(priv->tm_map);
goto err_put_device;
}
+ /* VER_0 have only tm_map */
+ if (!priv->srot_map)
+ priv->srot_map = priv->tm_map;
+
if (tsens_version(priv) > VER_0_1) {
for (i = VER_MAJOR; i <= VER_STEP; i++) {
priv->rf[i] = devm_regmap_field_alloc(dev, priv->srot_map,
@@ -769,6 +815,10 @@ int __init init_common(struct tsens_priv *priv)
ret = PTR_ERR(priv->rf[TSENS_EN]);
goto err_put_device;
}
+ /* in VER_0 TSENS need to be explicitly enabled */
+ if (tsens_version(priv) == VER_0)
+ regmap_field_write(priv->rf[TSENS_EN], 1);
+
ret = regmap_field_read(priv->rf[TSENS_EN], &enabled);
if (ret)
goto err_put_device;
@@ -791,6 +841,20 @@ int __init init_common(struct tsens_priv *priv)
goto err_put_device;
}
+ priv->rf[TSENS_SW_RST] = devm_regmap_field_alloc(
+ dev, priv->srot_map, priv->fields[TSENS_SW_RST]);
+ if (IS_ERR(priv->rf[TSENS_SW_RST])) {
+ ret = PTR_ERR(priv->rf[TSENS_SW_RST]);
+ goto err_put_device;
+ }
+
+ priv->rf[TRDY] =
+ devm_regmap_field_alloc(dev, priv->tm_map, priv->fields[TRDY]);
+ if (IS_ERR(priv->rf[TRDY])) {
+ ret = PTR_ERR(priv->rf[TRDY]);
+ goto err_put_device;
+ }
+
/* This loop might need changes if enum regfield_ids is reordered */
for (j = LAST_TEMP_0; j <= UP_THRESH_15; j += 16) {
for (i = 0; i < priv->feat->max_sensors; i++) {
@@ -806,7 +870,7 @@ int __init init_common(struct tsens_priv *priv)
}
}
- if (priv->feat->crit_int) {
+ if (priv->feat->crit_int || tsens_version(priv) < VER_0_1) {
/* Loop might need changes if enum regfield_ids is reordered */
for (j = CRITICAL_STATUS_0; j <= CRIT_THRESH_15; j += 16) {
for (i = 0; i < priv->feat->max_sensors; i++) {
@@ -844,7 +908,11 @@ int __init init_common(struct tsens_priv *priv)
}
spin_lock_init(&priv->ul_lock);
- tsens_enable_irq(priv);
+
+ /* VER_0 interrupt doesn't need to be enabled */
+ if (tsens_version(priv) >= VER_0_1)
+ tsens_enable_irq(priv);
+
tsens_debug_init(op);
err_put_device:
@@ -943,10 +1011,14 @@ static int tsens_register_irq(struct tsens_priv *priv, char *irqname,
if (irq == -ENXIO)
ret = 0;
} else {
- ret = devm_request_threaded_irq(&pdev->dev, irq,
- NULL, thread_fn,
- IRQF_ONESHOT,
- dev_name(&pdev->dev), priv);
+ /* VER_0 interrupt is TRIGGER_RISING, VER_0_1 and up is ONESHOT */
+ ret = devm_request_threaded_irq(
+ &pdev->dev, irq,
+ tsens_version(priv) == VER_0 ? thread_fn : NULL,
+ tsens_version(priv) == VER_0 ? NULL : thread_fn,
+ tsens_version(priv) == VER_0 ? IRQF_TRIGGER_RISING :
+ IRQF_ONESHOT,
+ dev_name(&pdev->dev), priv);
if (ret)
dev_err(&pdev->dev, "%s: failed to get irq\n",
__func__);
@@ -975,6 +1047,19 @@ static int tsens_register(struct tsens_priv *priv)
priv->ops->enable(priv, i);
}
+ /* VER_0 require to set MIN and MAX THRESH
+ * These 2 regs are set using the:
+ * - CRIT_THRESH_0 for MAX THRESH hardcoded to 120°C
+ * - CRIT_THRESH_1 for MIN THRESH hardcoded to 0°C
+ */
+ if (tsens_version(priv) < VER_0_1) {
+ regmap_field_write(priv->rf[CRIT_THRESH_0],
+ tsens_mC_to_hw(priv->sensor, 120000));
+
+ regmap_field_write(priv->rf[CRIT_THRESH_1],
+ tsens_mC_to_hw(priv->sensor, 0));
+ }
+
ret = tsens_register_irq(priv, "uplow", tsens_irq_thread);
if (ret < 0)
return ret;
diff --git a/drivers/thermal/qcom/tsens.h b/drivers/thermal/qcom/tsens.h
index f40b625f897e..8e6c1fd3ccf5 100644
--- a/drivers/thermal/qcom/tsens.h
+++ b/drivers/thermal/qcom/tsens.h
@@ -13,6 +13,7 @@
#define CAL_DEGC_PT2 120
#define SLOPE_FACTOR 1000
#define SLOPE_DEFAULT 3200
+#define TIMEOUT_US 100
#define THRESHOLD_MAX_ADC_CODE 0x3ff
#define THRESHOLD_MIN_ADC_CODE 0x0
@@ -25,7 +26,8 @@ struct tsens_priv;
/* IP version numbers in ascending order */
enum tsens_ver {
- VER_0_1 = 0,
+ VER_0 = 0,
+ VER_0_1,
VER_1_X,
VER_2_X,
};