Re: [PATCH V2 RESEND 3/4] PM / devfreq: bail out early if no freq changes in devfreq_set_target

From: Chanwoo Choi
Date: Tue Mar 23 2021 - 11:02:55 EST


On 21. 3. 23. 오후 4:20, Dong Aisheng wrote:
It's unnecessary to set the same freq again and run notifier calls.

Signed-off-by: Dong Aisheng <aisheng.dong@xxxxxxx>
---
drivers/devfreq/devfreq.c | 9 ++++++---
1 file changed, 6 insertions(+), 3 deletions(-)

diff --git a/drivers/devfreq/devfreq.c b/drivers/devfreq/devfreq.c
index 85927bd7ee76..a6ee91dd17bd 100644
--- a/drivers/devfreq/devfreq.c
+++ b/drivers/devfreq/devfreq.c
@@ -352,13 +352,16 @@ static int devfreq_set_target(struct devfreq *devfreq, unsigned long new_freq,
{
struct devfreq_freqs freqs;
unsigned long cur_freq;
- int err = 0;
+ int err;
if (devfreq->profile->get_cur_freq)
devfreq->profile->get_cur_freq(devfreq->dev.parent, &cur_freq);
else
cur_freq = devfreq->previous_freq;
+ if (new_freq == cur_freq)
+ return 0;

cur_freq is one of the OPP frequencies. But, new_freq is calculated from
governor algorithm. It means that new_freq is not one of the
frequencies. Actually, it is not efficient.

After devfreq->profile->target() which almost uses
devfreq_recommended_opp(), new_freq is one of OPP frequencies.

+
freqs.old = cur_freq;
freqs.new = new_freq;
devfreq_notify_transition(devfreq, &freqs, DEVFREQ_PRECHANGE);
@@ -375,7 +378,7 @@ static int devfreq_set_target(struct devfreq *devfreq, unsigned long new_freq,
* and DEVFREQ_POSTCHANGE because for showing the correct frequency
* change order of between devfreq device and passive devfreq device.
*/
- if (trace_devfreq_frequency_enabled() && new_freq != cur_freq)
+ if (trace_devfreq_frequency_enabled())
trace_devfreq_frequency(devfreq, new_freq, cur_freq);
freqs.new = new_freq;
@@ -390,7 +393,7 @@ static int devfreq_set_target(struct devfreq *devfreq, unsigned long new_freq,
if (devfreq->suspend_freq)
devfreq->resume_freq = new_freq;
- return err;
+ return 0;
}
/**



--
Best Regards,
Samsung Electronics
Chanwoo Choi